In this form of apparatus some part or other of the water is open to the atmosphere, either at the top of the boiler or at the top of one of the pipes, so that there is no danger from the bursting action of water heated above the boiling temperature. But, on the other hand, the water cannot well be conveyed to rooms at different elevations in the building. To increase the efficacy of the arrangement in this respect, the following adaptation has been suggested. A pipe is made to dip into an open boiler, reaching only an inch or two below the surface of the water, and passing round the room to be warmed, returns again to the boiler and dips again into the water, descending quite to the bottom of the boiler. An air-pump is connected with this pipe by a small tube; and the air in the pipe being exhausted by this means, the water rises into the pipes above the level of the boiler by atmospheric pressure, and the circulation then takes place by the hot water ascending through the pipe at the top of the boiler, and passing through the whole circuit of the pipe, it returns through the upper end of the pipe which reaches to the bottom of the boiler. In the last-described form of apparatus the water will rise in the syphon pipe to a height of about thirty feet above the boiler, being that elevation which is due to the action of the atmosphere on liquid flowing through a vacuum. But when a whole house or building is warmed by hot water in all the different floors or heights, a modification of the system, called the _high-pressure system_, is adopted. The apparatus on this system consists of a spiral coil of small iron pipe built into a furnace, the pipe being carried from the upper part of the coil, and entwined round the room intended to be warmed, forming a continuous pipe when again joined to the bottom of the coil. The size of the pipe is usually only half an inch in diameter internally, and an inch externally. A large pipe of about two and a half inches diameter is connected, either horizontally or vertically, with the small pipe, and is placed at the highest point of the apparatus. This, which is called the “expansion pipe,” has an opening near its lower extremity, by which the apparatus is filled with water, the aperture being afterwards secured by a strong screw; but the expansion pipe itself cannot be filled higher than this opening. After the water has been introduced, the screw is securely fastened, and the apparatus becomes completely closed in all parts. The expansion pipe, which is thus left empty, is calculated to hold about one-tenth or one-twelfth as much water as the whole of the small pipes; this being necessary in order to allow for the expansion that takes place in the volume of the water when heated, and which otherwise would inevitably burst the pipes, however strong they might be.