The plans of ships prepared in the designing department and drawing offices, to which reference has been made in the previous Chapter, are passed to the moulding loft, where the work of construction is commenced. This loft is situated in a substantial four-storey building, accommodating practically all the wood-finishing departments. Each floor has an area of 12,500 square feet; the ground and first floors are given up to the joiners and cabinet-makers, with their numerous machine tools, while the top floor is at present utilised for storing completed joiner work, etc. The moulding loft monopolises the third floor, and as the length is 240 ft. and the width 52 ft., there is ample space, as is shown on the engraving in Plate XL., facing page 94, for laying down full size deck-plating, stringers, margin plates, deck girders, etc., so that moulds or templates may be prepared for the iron workers. Armour-plates for warship belts, barbettes, and casemates are similarly prepared in template, to assist the makers to form them to the required curvature and size. [Illustration: Plate XL. THE MOULDING LOFT.] [Illustration: Plate XLI. BEAM SHEARING MACHINE. BEVELLING MACHINE. HYDRAULIC JOGGLING MACHINE.] The ironworkers' department is extensive and important. When the material is delivered into the yard, it is discharged from the railway wagons by a 5-ton electric overhead travelling high-speed crane, which stacks the plates and bars in such a way that any piece can be readily removed by the same crane for conveyance to the furnaces. There are six furnaces suitable for heating shell plates of the largest size, and angles and bars for frames, etc., up to 60 ft. in length. Adjacent to the furnaces are the screeve boards and the frame-bending blocks. The channel, bulb angle, or Z bars, used so extensively now for framing in large ships, are bevelled as they pass from the furnace to the bending blocks. This is done in a special machine made by Messrs. Davis and Primrose, Leith, and illustrated on Plate XLI., adjoining this page. The bars, as delivered from the rolling mills, have flanges at an angle of 90 deg., which is not suitable for taking the skin plating of ships. One angle has therefore to be altered, so that while the inner flange may lie at right angles to the keel-plate, that to the outside will fit closely to the shell plating throughout the entire length of the frame from keel to shear stroke, which may be 50 ft. or 60 ft. As the bar passes through the machine, the web is carried on an ordinary flat roller, while bevelling rolls, set to the desired angle, work on each side of one of the flanges to give it the desired set. There are several of these machines in use, and they run on rails laid across the front of the furnace, so that the angles, Z sections, or channels may be bevelled while passing out of the furnace on to the bending blocks. The manipulation of the plates from the furnace is by means of steam and electric winches.