The shoes of a horse have much to do with his, and consequently with his rider’s, comfort. It is therefore important to know that he is properly shod. To effect this, the shoe should be fitted to the foot, and not the foot to the shoe. [Illustration: _Plate XXXIV_ _Page 122._ Horse Equipments.] [Illustration: _Plate XXXV_ _Page 122._ The Parts of the Horse. First View of Mounting.] Neither heel nor frog should be pared more than merely to take off what is ragged; for no reproduction takes place here, as in the case of the hoof. Farriers ruin nearly all horses by doing otherwise. Indeed, they are not to be trusted with this operation, which, after shoeing, any gentleman may perform with his pocket-knife. The sole of the foot must not be hollowed out, but only the outer wall pared flat or even with the sole, and most at the toe. Nor, above all things, ought the farrier’s finishing rasp all round the edge of the horn immediately above the shoe to be permitted. Neither ought nails to be driven far backward towards the heel, where the horn is softer and more sensible, especially at the inner quarter. When a horse has a high heel, the foot, except the frog, may be pared flat, but not hollowed out or opened. When a horse has a low heel, the foot should be pared only at the toes. It is common to allow the fore part or toe of the hoof to grow long, thereby throwing the horse much on his heels. This position is unnatural, because, were the horse in a state of nature, without shoes, the toe, from constant contact with the ground, would be worn down to its proper level with the heel. This growth, then, of the fore part of the hoof, by throwing him on his heels, renders them tender, and causes lameness: while the foot, not being flat on the ground, also strains the ligaments of the fetlock joint. These evils may be obviated by doing as nature directs--by cutting away the toe to the proper level with the heel, so as to allow the foot to bear flat upon the ground. When a horse has a short pastern, he should have a short shoe, because a long one would compel him to bring his heel more backward than the unpliableness of his pastern would easily admit. The saddle should be proportioned to the size of the horse. Before, the bearings should be clear of the plate bone; behind, they should not extend further than within four inches of the hips; and their pressure should be equal on every part intended to be touched. The closer the saddle then comes the better, if neither the weight of the rider nor settling of the panel can possibly injure the withers or chine. Before mounting, the rider should examine whether the saddle, girths, straps, bits, bridle, &c., are all good and well fixed.