"A quadrangular oblong deal box, water-tight, being provided with holes or slits in the middle of each of its ends, just large enough to receive, the one the square iron rod to the end of which the blunt steel borer was fastened, the other the small cylindrical neck which joined the hollow cylinder to the cannon; when this box (which was occasionally closed above by a wooden cover or lid moving on hinges) was put into its place--that is to say, when, by means of the two vertical opening or slits in its two ends, the box was fixed to the machinery in such a manner that its bottom being in the plane of the horizon, its axis coincided with the axis of the hollow metallic cylinder, it is evident, from the description, that the hollow, metallic cylinder would occupy the middle of the box, without touching it on either side; and that, on pouring water into the box and filling it to the brim, the cylinder would be completely covered and surrounded on every side by that fluid. And, further, as the box was held fast by the strong, square iron rod which passed in a square hole in the centre of one of its ends, while the round or cylindrical neck which joined the hollow cylinder to the end of the cannon could turn round freely on its axis in the round hole in the centre of the other end of it, it is evident that the machinery could be put in motion without the least danger of forcing the box out of its place, throwing the water out of it, or deranging any part of the apparatus." Everything being thus ready, the box was filled with cold water, having been made water-tight by means of leather collars, and the machinery put in motion. "The result of this beautiful experiment," says Rumford, "was very striking, and the pleasure it afforded me amply repaid me for all the trouble I had had in contriving and arranging the complicated machinery used in making it. The cylinder, revolving at the rate of thirty-two times in a minute, had been in motion but a short time when I perceived, by putting my hand into the water and touching the outside of the cylinder, that heat was generated, and it was not long before the water which surrounded the cylinder began to be sensibly warm. "At the end of one hour I found, by plunging a thermometer into the box,... that its temperature had been raised no less than forty-seven degrees Fahrenheit, being now one hundred and seven degrees Fahrenheit. ... One hour and thirty minutes after the machinery had been put in motion the heat of the water in the box was one hundred and forty-two degrees. At the end of two hours... it was raised to one hundred and seventy-eight degrees; and at two hours and thirty minutes it ACTUALLY BOILED!