The changer of the hive should be made perfectly tight, so as to exclude all light from the drawers. Drawers should be small like No. 2, for all purposes except such as are used for multiplying colonies and transferring, which should always be large like No. 1. Hives should have elects on their sides, so as to suspend them in the air some distance from the floor of the apiary, the better to secure the bees from destruction by mice, reptiles, and other vermin. The back side or rear of the lower apartment of the hive should slant forward, so as to render the same smallest at the bottom, the better to secure the combs from falling when cracked by frost or nearly melted in hot weather. No timbers or boards should be placed very near the lower edge of the hive, because it facilitates the entrance of depredators. That the back side should slant forward, is obvious from the fact, that bees generally rest one edge of their combs on that side, and build towards the front in such a manner as to enter upon the same sheet where they intend to deposit their stores, when they first enter the hive, without being compelled to take any unnecessary steps. The bottom of the hive should slant downward from rear to front, so as to afford the greatest facility to the bees to clear their tenement of all offensive substances, and let the water, which is occasioned by the breath and vapor of the bees, run off in cold water. It also aids the bees very much in preventing the entrance of robbers. The bottom board should be suspended by staples and hooks near each corner of the hive, in such a manner as to afford a free entrance and egress to the bees on all its sides, which will better enable them to keep their tenement clear of the moths. There should be a button attached to the lower edge of the rear of the hive, so as to enable the apiarian to govern the bottom board in such a manner as to give all the air they need, or close the hive at pleasure. The hive should have two sticks placed at equal distances, extending from front to rear, resting on the rear, with a screw driven through the front into the end of the stick, which holds it fast in its place, and a ventilator hear the top of the lower apartment of the hive, to let off the vapor which frequently causes the death of the bees in the winter by freezing. The door to the chamber should be made to fit in the rabitings of the same against the jambs, in such a manner as to exclude the light from the windows of the drawers, and also to prevent the entrance of the little ants. It should also be hung by butts, or fastened by a bar, running vertically across the centre of the door, and confined by staples at each end. There should be three sheet-iron slides, one of which should be nearly as wide as the chamber, and one or two inches longer than the length of the chamber. The other two should be the same length of the first, and half its width only.