A Study of SplashesWorthington, A. M. (Arthur Mason)
Science
A Study of Splashes
Worthington, A. M. (Arthur Mason)
Splashes
This same surface-tension checks the rise of the crater, and would cause
it to subside again even without the action of gravity. Thus the
pressures of the sharply curved crater-edge on the liquid between the
crater walls are indicated by the dotted arrows in Fig. 10, and arise
from the surface-tension indicated by the full arrows. During the early
part of the splash the surface-tension is more important than gravity in
checking the rise of the walls. For, as the numbers show, the crater of
Series I is already at about its maximum height in No. 4, i.e. about
seven-thousandths of a second after first contact. In this time the fall
due to gravity would be only about 1/100 of an inch. Thus if gravity had
not acted the crater would only have risen about 1/100 of an inch
higher. The same reasoning applies to the rise of the central column,
but here the curvature at the summit is much less sharp. The numbers
show that the column reaches its maximum height in about 5/100 of a
second after its start in No. 10, and in this time the fall due to
gravity is about half an inch, so that gravity has reduced the height by
this amount.
[Illustration: FIG. 10]
The second principle which I will now mention enables us to explain the
occurrence of the jets and rays at the edge of the crater and their
splitting into drops.
It was shown in 1873 by the blind Belgian philosopher, Plateau,[D] that
a cylinder of liquid is not a figure of stable equilibrium if its length
exceeds about 3-1/7 times its diameter. Thus a long cylindrical rod of
liquid, such as Fig. 11, if it could be obtained and left for a moment
to itself, would at once topple into a row of sensibly equal,
equidistant drops, the number of which is expressed by a very simple
law, viz. that for every 3-1/7 times the diameter there is a drop, or
that the distance between the centres of the drops is equal to the
circumference of the cylinder.
[Illustration: FIG. 11]
The cause of this instability is the action of the same skin-tension
that we have already spoken of. Calculation shows, and Plateau was able
to confirm the calculation by experiment, that if through chance
agitations lobes are formed at a nearer distance apart than 3-1/7 times
the radius, with hollows between as in the accompanying Fig. 12, then
the curvatures will be such as to make the skin-tension push the
protuberances back and pull the hollows out. But if the protuberances
occur at any greater distances apart than the length of the perimeter,
then the sharper curvature of the narrower parts will drive the liquid
there into the parts already wider, thus any such an initial accidental
inequality of diameter will go on increasing, or the whole will topple
into drops.
[Illustration: FIG. 12]
At the last moment the drops are joined by narrow necks of liquid (Fig.
13), which themselves split up into secondary droplets (Fig. 14).
[Illustration: FIG. 13]
[Illustration: FIG. 14]
Public-domain text, read in full here on John Shaqi.
Reviews
Reviews
No reviews yet
Be the first to share your thoughts on this work.
Join the Discussion
Join the discussion
Sign in to leave a comment or review.
Sign InorCreate an account