(_i._) _Glass Tubes closed at one End._--If we wish to expose volatile substances to heat, with the exclusion of air as much as possible, or to ascertain the contents of water, or other volatile fluids, or for the purpose of heating substances which will decrepitate, we use glass tubes closed at one end. These tubes must be about one-eighth of an inch wide, and from two to three inches in length. They should be made of white glass, difficult of fusion, and free from lead. They should be closed at one end, as figured in the margin, Fig. 10. [Illustration: Fig. 10.] When a substance is to be examined for the purpose of ascertaining whether it contains combustible matter, as sulphur or arsenic, and where we wish to avoid oxidation, we use these tubes without extending the closed end, in order that there may be as little air admitted as possible, as is represented in tube B. But when a substance to be examined is to be tested for water, or other incombustible volatile matters, we employ tubes with little bulbs blown at one end, such as represented at tube A. Here there is room for a circulation of air at the bottom of the tube, by which the volatile matter rises more easily. In some cases, it is necessary to draw the closed end out to a fine point, as in the tubes C and D. Either one or the other of these tubes is employed, depending upon the nature of the substance used. The sublimates condense at the upper part of the tube _a_, and can be there examined and recognized. These tubes, before being used, must be thoroughly dried and cleaned. In experimenting with them, they should not be exposed at once to the hottest part of the flame, but should be submitted to the heat gradually. If the substance is of such a nature that it will sublime at a low heat, the tube should be held more horizontal, while a higher heat is attained by bringing the tube to a more vertical position. VARIOUS APPARATUS NECESSARY. _Edulcorator or Washing Bottle._--Take a glass bottle of the capacity of about twelve ounces, and close the mouth of it very tight with a cork, through which a short glass tube is fitted airtight. The external end of this tube is drawn out to a point, with a very fine orifice. The bottle should be filled about half full of water. By blowing air into the bottle through the tube, and then turning it downwards, the compressed air will expel a fine stream of water through the fine orifice with considerable force. We use this washing bottle, Fig. 11, for the purpose of rinsing the small particles of coal from the reduced metals. [Illustration: Fig. 11.]