in the saltpetre, this may be accomplished by following the process already given, viz: by collecting the precipitates, &c. determining their weights, and making the necessary allowance, for the new compounds, as the carbonates of lime, sulphate of barytes, muriate of silver, and the like. Baumé proposed the analysis of powder by sublimation, in order to separate the sulphur, using however a graduated heat. Another mode consists in distilling the powder in a retort with water, and collecting the sulphur and sulphuretted hydrogen gas, and then separating the charcoal, &c. A third process was recommended by Pelletier, after the separation of the nitre, by subliming a mixture of the residue with mercury, which, however, presents no advantages. The use of nitric acid has also been recommended, in order to acidify the sulphur. For this purpose nitric acid is poured on the residue, and the whole is digested for some time, renewing the acid as it is decomposed. By this means the carbon, as well as the sulphur, is acidified, and carbonic acid gas with deutoxide of azote are disengaged, leaving the sulphuric acid formed by the union of oxygen with the sulphur, in the remaining fluid, from which it is separated by nitrate of barytes, and its quantity ascertained by the sulphate of barytes produced. The proportion of sulphur, in the sulphuric acid, is then calculated. Caustic potassa has been employed for the separation of the sulphur from the charcoal. It unites with the sulphur, forming a sulphuret; and as sulphuretted hydrogen gas is also produced, the sulphuret must likewise contain the hydroguretted sulphuret of potassa. The charcoal is not acted upon. M. Vito Caravelli, professor of chemistry at Naples, (_Elements d'Artillerie_, 1773,) has given a more simple process for the separation of these substances, which depends on their specific gravity. When mixed with water, the sulphur will deposite, and the charcoal float on the fluid. Vauquelin directed his attention to this subject, and has recommended various processes, not only for the separation of the sulphur and charcoal, but also the nitre. The process of Smithson Tennant is nearly of the same nature. The separation of sulphur from charcoal may be effected more perfectly, according to Brande, by introducing the mixture into a small retort furnished with a stop cock, exhausted, and filled with chlorine gas; the chlorine will unite with the sulphur, forming a chloride, and leave the charcoal, which may be washed, dried, and weighed.