POLISHING. The polishing of stones, whether cabochon or facetted, is accomplished by the use of very finely powdered abrasives such as corundum powder, tripoli, pumice, putty powder, etc. Each gem material requires special treatment to obtain the best results. It is here that most of the trade secrets apply. The troubles of the lapidary in getting the keen polish that is so much admired on fine gems are many. In general, the polishing powder should not be quite as hard as the material to be polished, else it may grind rather than polish. The material should be used with water or oil to give it a creamy consistency. It should be backed by laps of different materials for different purposes. Thus, when backed by a fairly hard metal even tripoli, although much softer, will polish sapphire. On a lap of wood, tripoli would fail to polish hard materials, but would polish amethyst or other quartz gem. A change of speed of the lap, too, changes the effect of the polishing material. I have seen a lapidary, who was having no success at polishing an emerald, get very good results by using a stick as a brake and slowing down his lap. The polishing material must be of very uniform size, preferably water floated or oil floated, to give good results. The lap must be kept flat and true and the stone must be properly held, or the flatness of the facets, upon which brilliancy depends in part, will be destroyed during the polishing. The softer materials, such as opal, require treatment more like that accorded cut glass, and soft abrasive powders, such as pumice, suffice to polish them. Probably hardly two lapidaries would work exactly alike in their treatment of precious stones, and each guards his secrets, yet all use approximately similar general methods. Some have devised mechanical holders which permit the repeated cutting of stones to exactly the same angles, and that, too, with an accurate knowledge of the angles used. These angles can be definitely altered for different materials, according to their refractive indices. Other lapidaries produce very fine results by purely hand methods. These details have been gone into to give an idea of the methods of the lapidary and of the many variations in method. In general, however, the _slitting_ or _cleaving_, the _rubbing down_ to shape, the _smoothing out_ of all scratches and the _facetting_ and _polishing_ are done somewhat similarly by all lapidaries. Having now had a glimpse of the methods of the lapidaries, let us briefly consider what constitutes good "make" in stones other than diamond.