Slating the external surface of a wall, to keep out the rain or damp, is sometimes adopted: a high wall (nearly facing the south-west) of a house near the north-west corner of Blackfriars Bridge, London, has been recently slated from top to bottom, to keep out damp. However well timber may be seasoned, if it be employed in a damp situation, decay is the certain consequence; therefore it is most desirable that the neighbourhood of buildings should be well drained, which would not only prevent rot, but also increase materially the comfort of those who reside in them. The drains should be made water-tight wherever they come near to the walls; as walls, particularly brick walls, draw up moisture to a very considerable height: very strict supervision should be placed over workmen while the drains of a building are being laid. Earth should never be suffered to rest against walls, and the sunk stories of buildings should always be surrounded by an open area, so that the walls may not absorb moisture from the earth: even open areas require to be properly built. We will quote a case to explain our meaning. A house was erected about eighteen months ago, in the south-east part of London, on sloping ground. Excavations were made for the basement floor, and a dry area, “brick thick, in cement,” was built at the back and side of the house, the top of the area wall being covered with a stone coping; we do not know whether the bottom of the area was drained. On the top of the coping was placed mould, forming one of the garden beds for flowers. Where the mould rested against the walls, damp entered. The area walls should have been built, in the first instance, above the level of the garden-ground--which has since been done--otherwise, in course of time, the ends of the next floor joists would have become attacked by dry rot.