Acetylene, the Principles of Its Generation and Use: A Practical Handbook on the Production, Purification, and Subsequent Treatment of Acetylene for the Development of Light, Heat, and PowerLeeds, F. H. (Frank Henley)
Science
Acetylene, the Principles of Its Generation and Use: A Practical Handbook on the Production, Purification, and Subsequent Treatment of Acetylene for the Development of Light, Heat, and Power
Leeds, F. H. (Frank Henley)
Acetylene
prolonged influence of the most severe frost ever known to occur in the
neighbourhood where the plant is situated. If the holder is placed out of
doors in an exposed spot where heavy rains may fall on the top of the
bell, or where snow may collect there and melt, the water is apt to run
down into the seal, diluting the upper layers until they lose the frost-
resisting power they originally had. This danger may be prevented by
erecting a sloping roof over the bell crown, or by stirring up the seal
and adding more preservative whenever it has been diluted with rain
water. Quite small holders would probably always be placed inside the
generator-house, where their seals may be protected by the same means as
are applied to the generator itself. It need hardly be said that all
remarks about the dangers incidental to the freezing of holder seals and
the methods for obviating them refer equally to every item in the
acetylene plant which contains water or is fitted with a water-sealed
cover; only the water which is actually used for decomposing the calcium
carbide cannot be protected from frost by the addition of calcium
chloride or glycerin--that water must be kept from falling to its natural
freezing-point. From Mauricheau-Beaupré's experiments, referred to on
page 106, it would appear that a further reason for avoiding an addition
of calcium chloride to the water used for decomposing carbide should lie
in the danger of causing a troublesome production of froth within the
generator.
It will be convenient to digress here for the purpose of considering how
the generators of an acetylene apparatus themselves should be protected
from frost; but it may be said at the outset that it is impossible to lay
down any fixed rules applicable to all cases, since local conditions,
such as climate, available resources, dimensions, and exposed or
protected position of the plant-house vary so largely in different
situations. In all important installations every item of the plant,
except the holder, will be collected in one or two rooms of a single
building constructed of brick or other incombustible material. Assuming
that long-continued frost reigns at times in the neighbourhood, the whole
of such a building, with the exception of one apartment used as a carbide
store only, is judiciously fitted with a heating arrangement like those
employed in conservatories or hothouses; a system of pipes in which warm
water is kept circulating being run round the walls of each chamber near
the floor. The boiler, heated with coke, paraffin, or even acetylene,
must naturally be placed in a separate room of the apparatus-house having
no direct (indoor) communication with the rooms containing the
generators, purifiers, &c. Instead of coils of pipe, "radiators" of the
usual commercial patterns may be adopted; but the immediate source of
heat should be steam, or preferably hot water, and not hot air or
combustion products from the stove. In exposed situations, where the
Public-domain text, read in full here on John Shaqi.
Reviews
Reviews
No reviews yet
Be the first to share your thoughts on this work.
Elsewhere in the archive
Join the Discussion
Join the discussion
Sign in to leave a comment or review.
Sign InorCreate an account