Many buildings and monuments are made of stone, and many buildings use stone for decorative trim. Granite is now the most widely used stone for buildings, monuments, and bridges. Limestone is the second most used building stone. It was widely used before Portland cement became available in the early 19th century because of its uniform color and texture and because it could be easily carved. Sandstone from local sources was commonly used in the Northeastern United States, especially before 1900. Nationwide, marble is used much less often than the other stone types, but it has been used for many buildings and monuments of historical significance. Because of their composition, some stones are more likely to be damaged by acidic deposition than others. Granite is primarily composed of silicate minerals, like feldspar and quartz, which are resistant to acid attack. Sandstone is also primarily composed of silica and is thus resistant. A few sandstones are less resistant because they contain a carbonate cement that dissolves readily in weak acid. Limestone and marble are primarily composed of the mineral calcite (calcium carbonate), which dissolves readily in weak acid; in fact, this characteristic is often used to identify the mineral calcite. Because buildings and monuments made of limestone and marble are more likely to be damaged by acid precipitation, they are the main focus of this booklet. [Illustration: Memorial Bridge in Washington, D.C., is made of granite, the most widely used stone type.] [Illustration: Marble used as a trim on the First Bank in Philadelphia, Pennsylvania.] How do you recognize limestone and marble? The main difference between limestone and marble is that limestone is a sedimentary rock, typically composed of calcium carbonate fossils, and marble is a metamorphic rock. Limestone forms when shells, sand, and mud are deposited at the bottom of oceans and lakes and over time solidify into rock. Marble forms when sedimentary limestone is heated and squeezed by natural rock-forming processes so that the grains recrystallize. If you look closely at a limestone, you can usually see fossil fragments (for example, bits of shell) held together by a calcite matrix. Limestone is more porous than marble, because there are small openings between the fossil fragments. Marble is usually light colored and is composed of crystals of calcite locked together like pieces of a jigsaw puzzle. Marble may contain colored streaks that are inclusions of non-calcite minerals. [Illustration: Limestone is made of fossil fragments, held together with calcite; the shell near the center is about 1 cm across. Botanic Gardens building, Washington, D.C.] [Illustration: Marble is made of calcite crystals (white) and some colored grains of mica inclusions; the grains in a marble are locked together like jigsaw puzzle pieces.]