_General method of observation._--In the ordinary use of the microscope, the object to be examined is laid upon the middle of a slide, which is placed upon the stage. The object is then brought under the centre of the object-glass, the mirror inclined half towards the light and half towards the object, until the object is seen to be illuminated, when, upon looking through the eye-piece and adjusting the coarse and fine movements, the object as it comes into focus will be seen, as it were, drawn upon a white disk, which is called the “field.” When the object is wet, it cannot be viewed without the application of a cover, because the water evaporates and condenses upon the under surface of the object-glass. To avoid the danger of injuring the object-glass, or crushing the object by lowering the body and object-glass too much in adjustment to focus, the best plan is to lower the body by means of the coarse movement until the object-glass appears near the object to the eye placed on one side of the stage, and then to apply the eye to the eye-piece, and turn the milled head so as to raise the body and object-glass until the object is brought into focus. In the examination of an object, it is best to begin with a low power, so as to obtain a view of the general arrangement of its parts, and then to apply the higher eye-pieces and powers, so that the more minute structural details may be observed. _Illumination._--The illumination or proper management of the light in using the microscope is of very great importance. The best light, especially with the low powers, is daylight, particularly that reflected from white clouds; this is least injurious to the eyes. But as daylight cannot always be used for microscopic investigations, and as cloud-light is insufficient with the higher powers, some kind of artificial light must be supplied. That mostly used is the light of a reading oil lamp or of a gas-burner, a candle being quite useless, on account of the flickering of the flame with the slightest draught. A moderator lamp has the defect of too great height; otherwise this would be better than any other oil lamp. A powerful and excellent light for the highest powers is afforded by a short paraffine-oil lamp. As intently looking at strongly illuminated objects is injurious to the sight, the amount of light allowed to pass the diaphragm should be no more than is agreeable, and sufficient to show the object distinctly. In using the higher powers, the field is much less bright with the use of the same light than in the case of the lower powers; and difficulty is often found in obtaining sufficient light for the distinct vision of the object. The achromatic condenser is of most important service here; but it is sometimes requisite, even when this is used, to condense the light upon the mirror by a shallow bull’s-eye; or a large common metallic reflector may be used for the same purpose.