Instead of the last experiment, this may be employed if preferred: Burn a little S in a receiver. Put into an evaporating-dish, 5 cc. HNO3, and dip a paper or piece of cloth into it. Hang the paper in the receiver of SO2, letting no HNO3 drop from it. Continue this operation till a small quantity of liquid is found in the bottle. The fumes show that HNO3 has lost O. 2 HNO3 + SO2 = H2SO4 + 2 NO2. 91. Tests for H2SO4. Experiment 56.--(1) Test the liquid with litmus. (2) Transfer it to a t.t., and add an equal volume of BaCl2 solution. H2SO4 + BaCl2 = ? Is BaSO4 soluble? (3) Put one drop H2SO4 from the reagent bottle in 10 cc. H2O in a clean t.t., and add 1 cc. BaCl2 solution. Look for any cloudiness. This is the characteristic test for H2SO4 and soluble sulphates, and so delicate that one drop in a liter of H2O can be detected. (4) Instead of H2SO4, try a little Na2SO4 solution. (5) Put two or three drops of strong H2SO4 on writing-paper, and evaporate, high over a flame, so as not to burn the paper. Examine it when dry. (6) Put a stick into a t.t. containing 2 cc. H2SO4, and note the effect. (7) Review Experiment 5. (8) Into an e.d. pour 5 cc. H2O, and then 15 cc. H2SO4. Stir it meantime with a small t.t. containing 2 or 3 cc. NH4OH, and notice what takes place in the latter; also note the heat of the e.d. The effects of (5), (6), (7), and (8) are due to the intense affinity which H2SO4 has for H2O. So thirsty is it that it even abstracts H and O from oxalic acid in the right proportion to form H2O, combines them, and then absorbs the water. 92. Affinity for Water.--This acid is a desiccator or dryer, and is used to take moisture from the air and prevent metallic substances from rusting. In this way it dilutes itself, and may increase its weight threefold. In diluting, the acid must always be poured into the water slowly and with stirring, not water into the acid, since, as H2O is lighter than H2SO4, heat enough may be set free at the surface of contact to cause an explosion. Contraction also takes place, as may be shown by accurately measuring each liquid in a graduate, before mixing, and again when cold. The mixture occupies less volume than the sum of the two volumes. For the best results the volume of the acid should be about three times that of the water. 93. Sulphuric Acid made on a Large Scale involves the same principles as shown in Experiment 55, excepting that S02 is obtained by burning S or roasting FeS2 (pyrite), [Fig. 29.]