The following proportion of the mallets for rockets of any size, from one ounce to six pound, may be observed; but as rockets are seldon made less than one ounce, or larger than six pound, I shall leave the management of them to the curious; but all cases under one ounce, may be rammed with an ounce rocket mallet. Your mallets will strike more solid, by having their handles turned out of the same piece as the head, and made in a cylindrical form: let their dimensions be worked by the diameters of the rockets: for example; let the thickness of the head be three diameters, and its length four, and the length of the handle five diameters, whose thickness must be in proportion to the hand. Of the Proportion of Sky Rockets, with the Manner of heading them. Fig. 13. represents a rocket compleat without its stick, whose length from the neck is five diameters one sixth; the cases should always be cut to this length, after they are filled: M the head, which is two diameters high, and one diameter one sixth and a half in breadth; N the cone or cap, whose perpendicular height must be one diameter one third. Fig. 14. is the collar to which the head is fixed; this is turned out of deal or any light wood, and its exterior diameter must be equal to the interior diameter of the head; one sixth will be sufficient for its thickness, and round the outside edge must be a groove; the interior diameter of the collar must not be quite so wide as the exterior diameter of the rocket; when this is to be glued on the rocket, you must cut two or three rounds of paper off the case, which will make a shoulder for it to rest upon. Fig. 15, a former for the head; two or three rounds of paper well pasted will be enough for the head, which, when rolled, put the collar on that part of the former marked O, which must fit the inside of it; then with the pinching cord, pinch the bottom of the head into the groove, and tie it with small twine. Fig. 16, represents a former for the cone. To make the caps, cut your paper in round pieces, equal in diameter to twice the length of the cone you intend to make; which pieces being cut into halves, will make two caps each, without wasting any paper; having formed the caps, paste over each of them a thin white paper, which must be a little longer than the cone, so as to project about half an inch below the bottom; this projection of paper, being notch’d and pasted, serves to fasten the cap to the head. [Illustration: PLATE. 1]