The system of rigging or car suspension is simplicity itself and is tangential to the envelope. On either side there are six main suspensions of 25 cwt. stranded steel cable known as "C" suspensions. Each "C" cable branches into two halves known as the "B" bridles, which in turn are supported at each end by the bridles known as "A." The ends of the "A" bridles are attached to the envelope by means of Eta patches. These consist of a metal D-shaped fitting round which the rigging is spliced and through which a number of webbing bands are passed which are spread out fanwise and solutioned to the envelope. It will thus be seen that the total load on each main suspension is proportionally taken up by each of the four "A" bridles, and that the whole weight of the car is equally distributed over the greater part of the length of the envelope. Four handling guys for manoeuvering the ship on the ground are provided under the bow and under the stem. A group of four Eta patches are placed close together, which form the point of attachment for two guys in each case. The forward of these groups of Eta patches forms the anchoring point. The bridle, consisting of 25 cwt. steel cable, is attached here and connected to the forepart of the skids of the car. The junction of this bridle with the two cables from the skids forms the mooring point and there the main trail rope is attached. This is 120 feet long and composed of 2-inch manilla. This is attached, properly coiled, to the side of the car and is dropped by a release gear. It is so designed that when the airship is held in a wind by the trail rope the strain is evenly divided between the envelope and the car. The grapnel carried is fitted to a short length of rope. The other end of the rope has an eye, and is fitted to slide down the main trail rope and catch on a knot at the end. For steering and stabilizing purposes the S.S. airship was originally designed with four fins and rudders, which were to be set exactly radial to the envelope. In some cases the two lower fins and rudders were abandoned, and a single vertical fin and rudder fitted centrally under the envelope were substituted. The three planes are identical in size and measure 16 feet by 8 feet 6 inches, having a gross stabilizing area of 402 1/2 square feet. They are composed of spruce and aluminium and steel tubing braced with wire and covered by linen doped and varnished when in position. The original rudders measured 3 feet by 8 feet 6 inches. In the case, however, of the single plane being fitted, 4-feet rudders are invariably employed. Two kingposts of steel tube are fitted to each plane and braced with wire to stiffen the whole structure. The planes are attached to the envelope by means of skids and stay wires. The skids, composed of spruce, are fastened to the envelope by eight lacing patches.