I have never had much luck with two-piece stretchers, but use thin board stretchers in one piece with a "sword stick" on each side to fully stretch and admit the air to both sides of the skin. This cures the skin faster and better than when only one side is exposed to the air, says a Maryland trapper. [Illustration: POLE STRETCHERS.] When off from home, I use stretchers made from saplings, as boards suitable are not to be had everywhere, and cannot be bothered with when going light. To make these, cut osier, willow or hickory switches, straight and thick as the finger, about four feet long; cut two short pieces for rats 4 and 6 inches long and carefully bending the long piece. Nail these in with a small wire nail at each end. A handful of shingle or lath nails and a clump of osier sprouts will make a full outfit of stretchers for a temporary camp. * * * I know it is as much value in stretching your furs and preparing them for market as it is in trapping, writes a trapper. If you have no boards, go to your grocer or dry goods store and you can get all the boxes you want for 5 or 10 cents apiece. They must not be over 3/8 of an inch thick; if they are, plane them down smooth on both sides. I make what I call the two piece stretcher with a wedge for muskrats. Take a board 20 inches long, 3/8 inch thick, 6 inches wide large end, 2 1/2 inches small end. Taper back 5 inches from small end. Now take block plane and chaffer off each side an inch or more up and round it off. Round and chaffer small end the same, almost to an edge. Now draw a line thru the center of the board and saw it thru. Make a wedge the same length and thickness, 3/8 of an inch wide and tapering down to 1/10 of an inch. If a large skin, push it in between the halves. Bore a hole in large end and hang up in a cool ventilated place to dry. After three days pull out wedge, and your fur will slip right off without tearing. If the boards should warp over, tack a strip across the large end. The mink stretchers are made on the same plan. A board the same thickness, 30 inches long, 3 1/2 inches wide, taper down 2 1/8 small end round chaffer. For large mink insert wedge made one inch wide. Taper down to 2/8. For skunk and coon they are also good, only they are made on a larger scale. Now a word about casing. Pull your hide on so the back is on one side and the belly on the other. Pull nose over small end 1/2 inch. Put two tacks on each side, now pull down tight to large end and put two tacks each side, lay board on bench and take an old case knife, scrape off all meat and fat and be careful not to scrape too thin, so as not to cut the fibre of the skin. After you have scraped the flesh off, insert the wedge and your skin will be tight. Do not stretch your hide so it will make your fur look thin. * * *