Although the arrangement of the principal features of the Corinthian capital is horizontal, yet owing to the channelling of the leaves and the firmly springing scrolls the vertical direction appears to predominate. This verticality emphasises the function of the capital as a supporting feature, and is æsthetically satisfactory, being in harmony with the flutings of the shaft. [Illustration: No. 163. Corinthian Capital.] The effect produced by the capitals of the other two orders is horizontal, and suggests the idea of binding. They are equally satisfactory as giving contrast of direction. [Illustration: No. 164. Corinthian Capital. Detail giving divisions of height, and profiles.] _The Base_ In all the orders a square plinth is the lowest member of the base of the column. On this plinth rests a series of mouldings which follow the circular plan of the shaft. The shaft invariably terminates in a fillet, the diameter of which exceeds that of the column, and on to which the line of the shaft is carried by means of a curve. [Illustration: No. 165. Doric Base.] _Doric Base_ The Doric base is extremely simple. It consists of the square plinth on which rests a torus moulding surmounted by a smaller moulding of the same section and a fillet above. The width of the plinth is one and a third the diameter of the column, and its height a quarter diameter or half the total height of the base. The other half is made up of the large torus, the small torus and fillet. The torus moulding should be bold in projection, practically semi-circular and at the fullest part of its curvature in vertical alignment with the centres of the horizontal faces of the plinth block. The small torus and fillet are about equal in height. _Ionic Base_ [Illustration: No. 166. Ionic Base.] The Ionic base differs from the Doric in the introduction of a hollow or scotia moulding between the two torus mouldings. Æsthetically it may be considered more satisfactory in that the strong shadow obtained by the use of the scotia produces an effect of binding which adds to the impression of strength. The type is technically known as the Attic base. The total width is one and a third diameter. The height of half a diameter may be divided into three. One of these divisions will give the height of the plinth, one the large torus and the fillet above it, and the other the scotia and small torus with the fillets above and below. The fillets either side of the upper torus may be in the same vertical alignment. [Illustration: No. 167. Corinthian Base.] The smallest diameter of the base, which will be in the hollow of the scotia, should exceed the diameter of the shaft, or an effect of weakness will be imparted. As in the Doric base a curve of a quarter circle connects the shaft with the upper fillet. _Corinthian Base_ The orthodox base of the Corinthian order is similar to that of the Ionic, with an additional scotia and small torus with its accompanying fillets.