b. Take sitting position on floor with back against Pilot's armor plate. Squeeze in with Flight Engineer and brace foot across the aisle. Pad with chute and cushion. Exit: Engineer's hatch. Secondary Exit: Pilot's window. Radio Operator Bailout a. Destroy classified material. b. Send position obtained from Navigator. Exit: Nose wheel well, 2nd. Secondary Exit: Bomb-bay. Radio Operator Take-Off a. Take-off position: In seat. b. Procedure: Fasten safety belt. Face aft and brace head with hands behind neck, shoulders and back against upper turret. If time permits, remove astrodome prior to crash. c. Exit: Remove parachute and exit through astrodome. [Transcriber's note: To allow the information in the FUSE CHART to be presented within page width restraints, the original table has been reformatted into a multi-line format.] RADIO OPERATORS SUPER-FORTRESS FUSE CHART RADIO SET FUSE RATING NUMBER AND LOCATION PURPOSE 274N COMMAND RECEIVER 10 Amp. One active and one spare in each rec. In low V. line to dyn. 274N COMMAND MODULATOR 20 Amp. 2 active on right end of modulator and two spare on the left end In low V. line to dyn. in L.V. line to heaters. 348 LIAISON RECEIVER 5 Amp. In the receiver proper. In L.V. line to dyn. AN/ART-13 COLLINS TRANSMITTER. 1 Amp. In dynamotor proper. Breaks H.V. line if press. relay fails. Two circuit breakers on the base of the Collins dyn. In L.V. input to dyn & L.V. input Xmitter. 269G or AN/ARN 7 RADIO COMP. 5 Amp. One active and one spare in radio compass relay shield. Removes 115 V. 400 cycle from set. RC-43 MARKER BEACON RECEIVER 10 Amp. One active and one spare in radio compass relay shield. Removes L.V. from Radio Comp. & Marker Beacon. RC-36-B Interphone 15 Amp. 1 active & 1 spare in radio comp. relay shld. In L.V. line to dyn. AN/AIC-2 Interphone One circuit breaker somewhere near the amplifier. In L.V. line to dyn. ANTENNA REEL 10 Amp. Between bomb bays in fuse box #183 Removes L.V. from motor. ANTENNA REEL RELAY 2 Amp. 1 active & 1 spare in radio comp. relay shld. Removes L.V. from relay. 522 VHF COMMAND 40 Amp. Fuse box #862 located on right side fire control room. May have reset switch instead. In L.V. line to dynamotor 595/695 IFF 10 Amp. 1 active & 1 spare in radio comp. relay shld. In L.V. line to dynamotor RADIO OPERATORS SUIT 20 Amp. Engineers Aft fuse panel. Removes power from suit. RC 103 (B/L) BC-733-D Lateral receiver. 10 Amp. One active and one spare in Junction Shield, fuse box #586 located behind A/C seat. In L.V. line to dynamotor AN-ARN-5A (B/L) R-89/ARN-5A Vertical glide path receiver. 10 amp circuit breaker On front of Junction Shield, (fuse box #586) behind A/C's seat. In L.V. input to the set. The set has no dynamotor.