“A gun is a machine by which the force of expanding gas is utilized for the purpose of propelling a projectile in a definite direction.” It is essentially a metal tube closed at one end, of sufficient strength to resist the pressure of the gases caused by the combustion of the powder charge in the confined space at the closed end of the tube behind the projectile. The rapid combustion of the powder, which produces a high temperature, gives rise to a pressure uniformly exerted in all directions within the confined space. The energy exerted is used in forcing the projectile from the tube. TUBES Due to the effort of the large amount of superheated gas generated, which tends to expand in all directions, tremendous rending stresses are set up in the tube. Formerly these stresses were met by a sheer mass of metal, but, as the size of the projectiles increased and the necessary pressure to give them muzzle velocity increased, the size of the guns increased beyond the practical limits of mobility. This was at first offset by forgings of refined alloyed steels, but even these failed to keep pace with the increasing pressure desired. The new condition was met by the introduction of the “built-up” and the “wire-wrapped” guns. The modern built-up gun is made by assembling one or more superimposed cylinders around a central tube. The superimposed cylinders, whose inside dimensions are slightly smaller than the outside dimensions of those on which they are to be assembled, are expanded by heat sufficiently to allow them to be assembled over the tube. The subsequent contraction on cooling causes each of them to exert a uniform pressure on the cylinder immediately underneath. This method of assembling is called “shrinkage.” This gives a compression to the inner tube and a slight tension to the outer one. The compression is so much additional strength to the tube because it must first be overcome before the powder gases can exert a tension on the inner tube fibers. The exact amount of the compression and tension for all parts of a gun at rest or resisting an explosion is a matter of mathematical calculation. The built-up construction has been used in practically all our present day types of field artillery. THE WIRE-WRAPPED GUN. Wire-wrapped guns consist of: (a) An inner steel tube which forms a support on which the wire is wrapped and in which the rifling grooves are cut. (b) Layers of wire wrapped upon the tube to increase its resistance by the application of an exterior pressure as well as to add to the strength of the structure by their own resistance to extension under fire. (c) One or more layers consisting of a steel jacket and hoops placed over the wire with or without shrinkage. The jacket generally furnishes longitudinal strength to the guns, and the breech block is screwed into the jacket, or into a breech bushing, which is screwed into the jacket.