=To assemble the parts of cylinder after cleaning.=—The parts should be reassembled immediately after cleaning and inspection, and the cylinder filled with hydroline oil issued for that purpose. The piston should be moved back and forth in the cylinder by hand to make sure that all parts are correctly assembled and are without interference. The cylinder should then be assembled in the cradle and the gun pulled from battery by hand and permitted to counter recoil rapidly to insure that all parts are in proper position for firing. _This should never be done, however, unless the cylinder is known to be filled with oil._ In reassembling the parts the condition of the vulcanized-fibre washers between cylinder head and cylinder, and between cylinder-end stud and cylinder end should be noted; they should be replaced whenever necessary to prevent leakage. In removing and inserting the piston rod care should be taken to keep it central in the cylinder, so as not to bind, burr, or spring any parts. _The dismounting and reassembling of the parts of the cylinder should in every case be supervised by a commissioned officer._ Before firing an inspection should be made to ascertain that the different parts, especially the piston rod and the cylinder-end stud nuts, are correctly assembled. =To pack the stuffing box.=—The stuffing box is packed with five rings of Garlock’s hydraulic waterproof packing, 0.25 inch square. The packing is issued cut into rings of such size that the ends meet around the piston rod. The latter being assembled, each ring, placed so as to break joints with the preceding one, is forced in succession into its seat by a packing tool of copper or hard wood, one end of which is shaped like a carpenter’s gouge and the other end forms a handle strong enough to stand light taps from a hammer. Such a tool may be readily improvised by one of the battery mechanics. After the five rings are firmly seated in the box, screw the gland down on the packing. In assembling the glands be sure that _at least four_ of its threads are engaged with the threads of the cylinder head; otherwise the threads of the gland may be stripped in firing. With new packing it may be found difficult to insert more than four rings and secure sufficient engagement of the gland. In such a case the box should be packed with four rings and the piece fired a few rounds, after which the fifth ring should be inserted.