The Sitkan fire-drill spindle is unusually long and thick (fig. 1). Both hearth and drills are of the _Thuja gigantea_, a tree that enters so largely into the life of the Indians along this coast. The wood grinds off very well with much friction; at ordinary speed there is soon a small heap of powder at the bottom of the fire slot. The latter is deeply cut in from the side nearly to the center of the fire-hole. The whole hearth has been charred at the fire. This repels moisture, and also renders it easier to ignite the wood, charring being a process somewhat analogous to the decay of wood by rotting. If kept carefully in a dry place, this apparatus was perfectly adequate for the purpose of the Sitkan, and in his skillful hands would no doubt give the spark in a minute or so. The long drill would indicate that two worked at it consecutively to keep up a continuous motion, as will be noted in the use of the Aino drill (p. 551). For tinder, the bark of the arbor vitæ was used. It is finely frayed, and is much improved by being slightly charred. They also use, preferably, a tinder made from a fungus, because it is “quicker,” _i. e._, ignites more readily than the frayed bark. The hearth is squared and measures 23 inches; the drill is of equal length. Going southward from Sitka the next fire-making set in the series is from Bella-Bella, British Columbia. These Indians are of the Salishan stock, and are called Bilhulas. The horizontal is a piece of cedar wood dressed square on three faces. It is apparently a piece of an oar or spear handle. The fire holes are shallow, and the fire slots are quite narrow (fig. 2). The drills have been scored longitudinally near the rubbing end; this may be a device to cause the wood to wear away more rapidly, and furnish fuel to the incipient fire. Fire has evidently been made with this set. Both parts are 1½ feet long; the drill is much thinner than that of Sitka. The tinder is of frayed cedar bark.