_The Cuts of Beef._--The general method of cutting up a side of beef is illustrated in Fig. 1, which shows the relative position of the cuts in the animal and in a dressed side. The neck piece is frequently cut so as to include more of the chuck than is represented by the diagram. The shoulder clod is usually cut without bone, while the shoulder (not indicated in diagram) would include more or less of the shoulder blade and of the upper end of the fore shank. Shoulder steak is cut from the chuck. In many localities the plate is made to include all the parts of the fore quarter designated on the diagrams as brisket, cross ribs, plate, and navel, and different portions of the plate, as thus cut, are spoken of as the “brisket end of plate” and “navel end of plate.” This part of the animal is largely used for corning. The ribs are frequently divided into first, second, and third cuts, the latter lying nearest the chuck and being slightly less desirable than the former. The chuck is sometimes subdivided in a similar manner, the third cut of the chuck being nearest the neck. The names applied to different portions of the loin vary considerably in different localities. The part nearest the ribs is frequently called “small end of loin” or “short steak.” The other end of the loin is called “hip sirloin” or “sirloin.” Between the short and the sirloin is a portion quite generally called the “tenderloin,” for the reason that the real tenderloin, the very tender strip of meat lying inside the loin, is found most fully developed in this cut. Porterhouse steak is a term most frequently applied to either the short steak or the tenderloin. It is not uncommon to find the flank cut so as to include more of the loin than is indicated in the figures, in which case the upper portion is called “flank steak.” The larger part of the flank is, however, very frequently corned, as is also the case with the rump. In some markets the rump is cut so as to include a portion of the loin, which is then sold as “rump steak.” The portion of the round on the outside of the leg is regarded as more tender than that on the inside, and is frequently preferred to the latter. As the leg lies upon the butcher’s table this outside of the round is usually on the upper, or top, side, and is therefore called “top round.” Occasionally the plate is called the “rattle.” In Fig. 2 is shown a side of beef with the various cuts indicated as used for commercial designation. [Illustration: 1. Shank 5. Rib 9. Clod 2. Round 6. Flank 10. Neck 3. Rump 7. Plate 4. Loin 8. Chuck Tenderloins, Sirloin Butts and Strips cut from No. 4. Rib Rolls cut from No. 5. FIG. 2.--COMMERCIAL CUTS OF BEEF.--(_Courtesy of Armour & Co._)] In Fig. 6 (page 20) is shown the interior view of a hog carcass with the cuts indicated as known to the trade. [Illustration: FIG. 3.--DIAGRAM OF CUTS OF VEAL.--(_Nutrition Bulletins, Office of Experiment Stations._)]