As I said before I baited with fish when I could get them; but those trappers who used them for mink alone, never used bait, but attracted the mink into the trap by means of mink musk rubbed on the trip board. I caught quite a lot of skunks in box traps, and it is a nice way to catch these animals, for the trap may be carried to the nearest water and the catch drowned by holding the trap beneath the surface. It is advisable always, to place a weight--a few stones or wet chunks--on the cover, as this will make it more certain in its action. These traps are specially suitable for catching animals alive and uninjured, for breeding purposes, and now, that so many people are interested in raising fur-bearing animals, there is a ready sale for live animals, and this matter should be given attention. [Illustration: Box Trap with Swing Gate.] I have used another style of box-trap for muskrats, but is not intended for catching the animals alive, and the muskrats are always drowned. It is a simple box or square tube of boards, 6 x 6 x 24 or 26 inches, open at both ends. A wire screen is fastened over one end, and a loosely hinged gate of pointed wires is hung in the other end. I used for the gate, pieces of umbrella ribs, cut about eight inches long and the ends filed sharp. With the wires cut this length the gate will hang at an angle of forty-five degrees, or more, and will push in easily, allowing the animal to enter the trap without effort; but once inside, escape is impossible, as the gate cannot be pushed out, and even if the captured animal should raise the gate and attempt to creep under it, the pointed wires will catch in its back and prevent escape. They are set in the dens, under water, and if the mouth of the den is too large, the space around the trap should be closed with sods. Set in this way, it will catch any muskrat that attempts to leave the den, and I have caught three at one time in such a trap. While muskrats caught in this way are always drowned, other animals, such as: mink, skunk and opossum, may be taken alive by setting the trap in the mouth of the den, blocking up all side openings. The width of the trap as shown in the cut, is considerably out of proportion, when compared with its length--it being drawn this way to show more clearly the working of the swing gate. A very effective skunk trap may be made from an old barrel. The barrel is pivoted to a pair of stakes, driven firmly into the ground along a bank or hillside, where skunks are found, and the bait is fastened on the bottom of the inside of the barrel. This trap is shown plainly in the illustration. It will be apparent to all that when the skunk, in approaching the bait, passes the center, where it is hinged to the stakes, the barrel tips over, and it will be impossible for the animal to escape.