In the spring of the year, hay produced milk is comparatively poor and thin. When it reaches the manufacturer’s hands it is generally as sweet as a rose in regard to acid, although not always so in regard to stable tang. When it has been transformed into curd it must be scalded high enough to cook it, whether that takes a temperature of 98°, 100° or 110° Fahrenheit. Don’t think, as some do, that the curd is cooked when it has reached the temperature you are using—generally it is not more than half cooked then. We will say you began making cheese on the first day of April. You are not an expert at the business and, being anxious to make a good beginning, feel a trifle nervous over the situation. Keep cool and bring the temperature of the curd up to 100°. On reaching this heat immediately cover up the vat with the carpet-like canopy previously described. Be sure and give it a thorough rake stirring the last thing on reaching the scalding point. If the make-room is reasonably warm the canvas roof will keep the whey at a mercurial heat of 100° for a long while. After a few minutes examine the curd and see how it is progressing. Stir it up occasionally—once in fifteen minutes or so is sufficient—and after it has stood an hour and a half at 100°, if it does not squeak sharply between the teeth when chewed or immediately fall apart when squeezed dry of whey in a double-handful, you may be assured that 100° was too low a temperature at which to cook it. The object is to cook at the lowest temperature which will do the business within a reasonable time. The higher the temperature used, the quicker it will be cooked, but it will require more milk to make a pound of cheese. A good yield and a good quality must both be gotten out of the milk—these are fine points in cheese making. The curd we have spoken of has stood in the whey at 100° degrees for one hour and a half and is yet insufficiently cooked. An hour longer at the same temperature would probably cook it to the right degree, but there are objections to letting curd stand in the whey so long—it gets whey soaked and begins to disintegrate slightly, even when no acid is perceptible. So, after a ninety minute test, (or, better yet, before), raise the temperature two, four, six or ten degrees, as your judgment warrants, and bring it to a firm consistency as quickly as possible.