These lock-nuts must be screwed on with two monkey-wrenches, forced in opposite directions, so that one nut will be driven tightly against the other. This is to prevent the turning of the table from unscrewing the nuts. Insulators For telegraph and telephone lines, where pole, tree, or building attachments are necessary, insulators must be used to carry the wires without loss of current. The regular glass, porcelain, or hard rubber insulators, made for pole and bracket use, are of course the best. They can be purchased at any supply-house for a few cents each, but there are other devices which will answer equally well and which will cost little or nothing. Obtain some bottles of stout glass, the green or dark glass being the toughest; then carefully break the bottle part away. In doing this hold the bottle by the neck, with a piece of old cloth wrapped about it, to prevent the glass chips from flying. Save all of the neck and part of the shoulder, as shown in Fig. 9, so that the wire and its anchoring loop will not slip off and fall down on the peg or cross-tree. Hard-wood pegs cut from sticks one inch and a half square should be whittled down so that they will fit in the neck and come up to the top. The pegs should be long enough at the bottom to permit of their being fastened to the supporting poles, trees, or building. In Fig. 10 three ways of attaching insulators are shown. At A the peg is nailed to the top of a pole, or a hole is bored in the pole and the peg driven down in it. At B two sticks with peg ends are nailed to a pole in the form of a [V], and across the sticks a cross-brace is made fast to prevent the sticks from spreading or dropping down. This cross-brace is made fast to both the sticks and the pole so as to form a rigid triangle. At C the usual form of cross-tree, or [T] brace, is shown. The pegs may be nailed to the face of the cross-plate, or holes may be bored in the top and the pegs driven down into them. If the cross-piece is more than two feet long, bracket-iron should be screwed fast to the pole and brace at both sides, as shown at C. Where a cross-plate is made fast to a pole, a lap should be cut out so that the plate can lie against a flat surface rather than on a round one (see D in Fig. 10). The shoulder of the bottle-necks must not rest on a cross-piece, or touch anything that would lead to the ground or to other wires. The shoulder acts as a collar, and so sheds water that in wet weather the current cannot be grounded through the rain. The underside of the collar should always be dry, and also that part of the peg protected by the collar, thereby insuring against the loss of current. The relative position of insulator and peg is shown at Fig. 9, and if the pegs are cut carefully the bottle-necks should fit them accurately. Joints and Splices