An enclosed push-button is shown in Fig. 2. It is made of the cover or body of a wooden box, a spool-end, and several other small parts. A round piece of thin wood is cut to fit inside the box and so form the base for the button. On this the spring strip is attached with screws, and the wire ends are made fast, as shown in Fig. 3. The wires are carried through the bottom of the base and along grooves to the edge, and thence to their final destination. The end of a spool is cut off and glued to the top of the box, as shown in Fig. 2, and a hole is made in the box to correspond in size with that in the spool. Through this aperture the button (cut from a wooden dowel or shaped out with a knife) passes, so that the end projects about a quarter of an inch beyond the spool. To prevent the button from falling out, a small steel nail should be driven across the inner end, or a washer may be tacked to the end of the stick, as shown in Fig. 4. [Illustration: FIG. 1] [Illustration: FIG. 2] [Illustration: FIG. 3] [Illustration: FIG. 4] The button is mounted by screwing the base fast to the door or window casing, it being understood that the wires have been first arranged in place. The button is then set in the hole and the cap is placed over the base, covering it completely. By means of small screws, passed through the rim of the box and into the edge of the base, the cap is held in place. A coat of paint or varnish will finish the wood-work nicely, and this home-made button should then answer every requirement. Switches and Cut-outs In electrical equipment and experimental work, switches and cut-outs will be found necessary, particularly so for telegraph and telephone lines. Care should be taken to construct them in a strong and durable fashion, for they will probably be subjected to considerable wear and tear. A simple switch (Fig. 5) is made from a base-block of wood three inches long, two wide, and half an inch in thickness, together with some small metal parts. It has but one contact-point, and that is the brass-headed tack (T in Fig. 5) driven through the binding-post, the latter being a small plate of brass, copper, or even tin screwed to the base-block. The end of a wire is caught under the screw-head before it is driven down. A similar binding-post is arranged at the lower side of the block, and the movable arm is attached to it with a screw. Between the arm and the post-plate there should be a small copper washer, to make it work more easily. The arm is cut from a thin piece of hard sheet brass or copper (tin or zinc will also answer very well), and at the loose end the half of a small spool is attached, with a brass screw and washer, to serve as a handle. The end of the screw that passes through a hole in the arm is riveted to the under side to hold it securely in place. This arrangement is shown in Fig. 6. [Illustration: FIG. 5] [Illustration: FIG. 6] [Illustration: FIG. 7] [Illustration: FIG. 8] [Illustration: FIG. 9]