This winding-rack makes it easy to handle the core-tube while putting on the layers of wire, and it holds the tube securely while the wraps of paper and shellac are applied. The secondary coil is laid over the primary, and should be of Nos. 30 to 36 insulated copper wire. The finer the wire the higher the resistance and the longer the spark, but nothing heavier than No. 30 should be used. Begin by making one end of the wire fast to a binding-post; then turn the core-tube with one hand, holding the wire in the other. Take care not to bind the wire nor stretch it, but wind it on smoothly and evenly, like the coils of thread on a new spool of cotton or silk. Be very careful to avoid kinks, breaks, or uninsulated places in the wire. Should the wire become broken, give the coil a coat of shellac to bind the wound strands; then make a fine twisted point and cover it with the silk or cotton covering, with a coat of shellac to hold it in place, and proceed with the winding. Between each layer of wire place a thin sheet of paper and coat it with paraffine, or shellac, to make a perfect insulation; then proceed with the next layer. With a battery and small bell test the wire layers occasionally to see that everything is all right, and that there are no breaks or short circuits. This is very necessary to avoid making mistakes, and, considering the time and care spent in winding the coils, it would be a great disappointment if the coil were defective. [Illustration: FIG. 17] [Illustration: FIG. 18] About one pound and a half of wire should constitute the secondary coil, and, if possible, it is best to have it in one continuous strand, without splices. Over the last coil, after the winding is completed, several thicknesses of paper should be laid and well coated with shellac between each wrap. This is a protector to insure the fine wire strands from damage. To improve the appearance of the coil a wrap of thin black or colored leather may be glued fast, with the seam or point at the under side. The ends of the wires forming the primary coil should be made fast to the binding-posts at one end, while those of the secondary coil should be attached to the posts at the other end. For the core, obtain some soft iron wire, about No. 18, and cut a number of lengths. Straighten these short wires and fill the tube with them, packing it closely, so that the wires will remain in place under a mutual pressure. It is better to make a core of a number of rods or wires rather than to have it of one solid piece of soft iron. Now, from hard-wood, cut a base three-quarters of an inch thick, five or six inches wide, and twelve inches long. Attach the coil to the base by means of screws passed up through the board and into the lower edges of the end-blocks. The wood is to be stained and given several successive coats of shellac.