=Annealing Glass=: Annealing lessens sensibly the risk of breakage. Pack the glass snugly in a boiler, fill with cold water, bring to a boil, keep simmering three to four hours, then throw over a thick cloth and let cool very slowly. Remove only when fully cold. Especially useful for thin tumblers, lamp chimneys, and finger bowls. Put a board or a handful of clean sticks in the bottom of the boiler, so the heat shall not break things set lowest. =Knives and Forks=: Have a pitcher just tall enough to hold knives, up to the handle. Do not quite fill it with very hot borax suds, stand knives in it, and leave till other things are out of the way, then wash blades, wipe off handles, rinse very quickly in clear tepid water, wipe dry, polish with a clean chamois, and hold with a clean cloth in putting away. This to save finger marks which grow often to stains or tarnishes upon knives seldom used. All-silver knives can be treated the same as other silver or plated things—still pitcher-washing is as good for them as any other. Ivory handles or pearl ones, or those of stag-horn or composition, all are injured by either soaking or very hot water. Carving-sets are frequently defaced hopelessly by rubbing the handles with scouring-soap. Instead use only lather, washing it off instantly. If suspicious of grease in the seam, wrap a fine-pointed skewer in thin cloth and run all around, pressing hard. Wipe knife handles very dry, else lay them for ten minutes in gentle heat to expel possible moisture around the rivets. =Restoring Antique Furniture=: Take out grease or ink spots (see section Spots and Stains), then go over with a turpentine cloth sopping wet, rub and rub and rub. Follow with an alcohol cloth and more rubbing, then a wash in strong hot suds, followed by rubbing dry. Now take stock of the surface. If there are dents, raise them by laying on very wet blotting-paper and drying it with a blazing-hot iron. Repeat if necessary—steam does the work. Sandpaper away scratches, or rub them with emery and a little oil, or scrape with broken glass. Go over again with turpentine to remove the last traces of varnish or grime. Then sandpaper to a new surface, and either oil, varnish, or give a wax finish (see section Renovators). Before resurfacing drive up loose dowels, wedging them tight, glue afresh rickety joins, strengthening them further with slender brads driven in from the under side. Glue broken bits in place—if they are missing, make the break smooth and fit into it a new piece. Cut the old wood, slanting outward—thus it is possible to drive very short brads from underneath. A vise helps greatly in such repairs—the harder held the pieces, the firmer and less visible the join. After it is dry, sandpaper; if the new wood fails to match the old, stain and rub down before waxing or polishing. Tiny gaps can be filled with putty mixed with dry color approaching that of the wood. This will take either oil stain or a wax finish.