After the boring, then, of the barrel, comes the turning of the outside of it. The piece is supported in the lathe by means of mandrels inserted into the two ends of it, and there it slowly revolves, bringing all parts of its surface successively under the action of a tool fixed firmly in the right position for cutting the work to its proper form. Of course the barrel has a slow progressive as well as rotary motion during this process, and the tool itself, with the rest in which it is firmly screwed, advances or recedes very regularly and gradually, in respect to the work, as the process goes on, in order to form the proper taper of the barrel in proceeding from the breech to the muzzle. The main work however in this turning process is performed by the rotation of the barrel. The workman thus treats his material and his tools with strict impartiality. In the _boring_, the piece remains at rest, and the tool does its work by revolving. In the _turning_, on the other hand, the _piece_ must take its part in active duty, being required to revolve against the tool, while the tool itself remains fixed in its position in the rest. Among the readers of this article there will probably be many thousands who have never had the opportunity to witness the process of turning or boring iron, and to them it may seem surprising that any tool can be made with an edge sufficiently enduring to stand in such a service. And it is indeed true that a cutting edge destined to maintain itself against iron must be of very excellent temper, and moreover it must have a peculiar construction and form, such that when set in its proper position for service, the cutting part shall be well supported, so to speak, in entering the metal, by the mass of the steel behind it. It is necessary, too, to keep the work cool by a small stream of water constantly falling upon the point of action. The piece to be turned, moreover, when of iron, must revolve very slowly; the process will not go on successfully at a rapid rate; though in the case of wood the higher the speed at which the machinery works, within certain limits, the more perfect the operation. In all these points the process of turning iron requires a very nice adjustment; but when the conditions necessary to success are all properly fulfilled, the work goes on in the most perfect manner, and the observer who is unaccustomed to witness the process is surprised to see the curling and continuous shaving of iron issuing from the point where the tool is applied, being cut out there as smoothly and apparently as easily as if the material were lead. THE STRAIGHTENING.