The month of September was drawing to its close, and the gang of loggers belonging to Camp No. 10 of the Northwest Lumber Company, which operated in the vast timber belt clothing the northern flanks of Mount Rainier, were about to knock off work. From earliest morning the stately forest, sweet-scented with the odors of resin, freshly cut cedar, and crushed ferns, had resounded with their shouts and laughter, the ring of their axes, the steady swish of saws, and the crash of falling trees. To one familiar only with Eastern logging, where summer is a time of idleness, and everything depends on the snows of winter, followed by the high waters of spring, the different methods of these Northwestern woodsmen would be matters of constant surprise. Their work goes on without a pause from year's end to year's end. There is no hauling on sleds, no vast accumulations of logs on the ice of rivers or lakes, no river driving, no mighty jams to be cleared at imminent risk of life and limb--nothing that is customary in the East. Even the mode of cutting down trees is different. The choppers--or "fallers," as they are called in the Northwest--do not work, as do their brethren of Maine or Wisconsin, from the ground, wielding their axes first on one side and then on the other until the tree falls. The girth of the mighty firs and cedars of that country is so great at ordinary chopping height that two men working in that way would not bring down more than two trees in a day, instead of the ten or a dozen required of them. So, by means of what are known as "spring-boards," they gain a height of eight or ten feet, and there begin operations. The ingenious contrivances that enable them to do this are narrow boards of tough vine maple, five or six feet long, and about one foot wide. Each is armed at its inner end with a sharp steel spur affixed to its upper side. This end being thrust into a notch opened in the tree some four feet below where the cut is to be made, the weight of a man on its outer end causes the spur to bite deep into the wood, and to hold the board firmly in place. Having determined the direction in which the tree shall fall, and fixed their spring-boards accordingly, two "fallers" mount them, and chop out a deep under cut on the side that is to lie undermost. They work with double-bitted or two-edged axes, and can so truly guide the fall by means of the under cut that they are willing to set a stake one hundred feet away and guarantee that the descending trunk shall drive it into the ground. With the under cut chopped out to their satisfaction, they remove their spring-boards to the opposite side, and finish the task with a long, two-handed, coarse-toothed saw.