(1) A plank 2.5 metres x 9.5 centimetres x 4 centimetres, set on edge and screwed to a table at either end. (2) A head-rest 45 centimetres high, 35 centimetres broad and 15 centimetres deep. Attached to the centre of the lower strip of the frame is a concave trough for the chin. Another trough, shaped to fit over the vertex and with a strip of wood fastened to the front of it for the forehead, slides up or down within the frame. The attachment for the forehead can be moved and fixed at various positions antero-posteriorly. By means of these devices the head can be securely fixed in any position desired without discomfort to the subject. In order to have the eyes always in the same plane and at a known distance from the apparatus at the other end of the plank, a hole was made in either side of the frame with its centre at a level of the eyes. Extending through the vertical diameter of each hole is a fine wire. Fitted into the inner portion of each hole is a cardboard tube 10 centimetres long: the inner end of each tube contains a vertical wire so arranged that the four wires all fall into a plane at right angles to the long direction of the plank. A mirror at the outer exit of either hole enables the experimenter to align the tips of the subject's corneæ with the wires. Two parallel strips of wood are so attached to the "head-rest" end of the plank--one below and the other above it--that they can be rotated laterally upon the plank, with the bolt which secures them to it for a centre of rotation. Opposite this centre, and attached to the anterior surface of the upper parallel strip is a wire needle 25 centimetres long. By means of a quadricircular piece of cardboard attached to the plank at the end of the needle, the extent of rotation to the right or left can be read off in degrees. (The point midway between the two corneal tips when they are aligned with the wires is in the same axis of rotation as the head-rest.) A vertical iron rod 50 centimetres long extends upwards from either end of the parallel strips, and upon these rods the frame of the head-rest can be moved up or down by means of thumb-screws upon which it rests.