_The Collie Portable Mercurial Barometer._—This instrument is not likely to be broken in travelling. It is quickly set up, and from such tests as have been applied, it appears to give excellent results. The cistern and vacuum tube at the top are of equal diameter, and are connected by a flexible tube, and the difference in level of the mercury may be measured directly by means of a graduated rod, or as in Deasy’s mounting by means of a vernier. There is no attached thermometer, but if the instrument be used in the open air, and is exposed for ten minutes or a quarter of an hour before using, it will be sufficient to note the temperature of the air in the usual way. The upper end (Fig. 7) is about 2.5 inches long, and contains an air-trap, into which all the air that may accidentally enter the barometer, either by the tap leaking, through the rubber tubing, or through either of the joints, must find its way. The lower or reservoir end (Fig. 8) is about 4.5 inches long, and has an air-tight glass tap about an inch below the broad part. These ends are forced into the rubber tubing, and, as an additional precaution against leakage, copper wire is bound round the joints. The scale is cut on an aluminium bar, along which two carriages, to which the barometer is attached, move up and down, and they can be clamped to the bar at any place (Fig. 6). By means of the verniers attached to the carriages, which are divided to 0.002 of an inch, it is easy to estimate the height of the mercury to 0.001. To use the barometer, the carriages are put on the scale bar; the lower one is clamped at the bottom of the bar, and the upper one some inches higher up; the barometer is attached to the carriages by clamps which fit over the joints; the rubber cap is removed from the reservoir end, the tap opened, the verniers put in the middle of their runs, and the upper carriage moved up the bar until there is a vacuum. By means of the screws on the right of the carriages the verniers are moved up or down until the top of the mercury at each end is in line with the edges of the rings attached to the verniers, which fit round the glass ends. Both verniers are then read, and the difference gives the height of the barometer. The rubber cap on the reservoir end is merely to prevent the small quantity of mercury, which should be left above the tap when it is closed, from being shaken out when travelling. [Illustration: FIG. 6. THE COLLIE BAROMETER, WITH THE DEASY MOUNTING, IN ITS NORMAL WORKING POSITION. FIG. 7. THE UPPER CARRIAGE AND VERNIER ON A LARGER SCALE, WITH BAROMETER ATTACHED. FIG. 8. THE LOWER CARRIAGE AND VERNIER, WITH RESERVOIR END OF BAROMETER ATTACHED. (Same scale as Fig. 7.)]