For over 100 years the fishermen of Gloucester have been guided back to their home port by a lighthouse on Eastern Point. The present brick tower, painted a gleaming white, and standing on the long rocky point forming the eastern side of the harbor, was built in 1890, replacing, on the same foundation the original tower built in 1832. Before 1832 a still older lighthouse, on Ten-Pound Island well inside of the harbor, had served as an entrance light, but this light was never visible until ships had actually found the entrance, hence the building of a lighthouse on the Eastern Point where it could be seen from far offshore. Eastern Point Lighthouse is equipped with a power light and a fog signal. Coast Guardsmen also control the radiobeacon, located on the end of the breakwater. (1) (2) _MASSACHUSETTS_ MINOTS LEDGE LIGHTHOUSE Minots Ledge is one of the “Cohasset Rocks” which had been the scene of countless wrecks since earliest times. Between 1832 and 1841 there were 40 wrecks on this and neighboring reefs. Between 1817 and 1847, it was estimated that 40 lives and $364,000 in property had been lost in shipwrecks in the vicinity of Minots Ledge, off Cohasset, Mass. In 1843, Inspector I. W. P. Lewis, of the Lighthouse Service, emphasized the great need for a lighthouse on Minots Ledge and his judgment was sustained by Capt. William H. Swift, of the United States Topographical Bureau, who recommended an iron-pile lighthouse as offering less resistance to the waves than a stone tower. The ledge was barely 20 feet wide and was exposed at low tide, being dry only 2 or 3 hours a day. On this narrow rock construction was begun in the spring of 1847 of a 75-foot open-work iron light structure. The men could only work on very calm days when the tide was at its ebb. The work was conducted from a schooner which remained near the ledge, unless the sea was rough, with the workmen sleeping on board. If a storm threatened, the schooner put into Cohasset Harbor until it was over. Nine holes were drilled into the solid rock, each 12 inches wide and 5 feet deep. Eight were placed in a circle, 25 feet in diameter, with the ninth in the center. Iron piling, 10 inches in diameter were then cemented into each hole. Four men worked in 20-minute shifts at the drilling from a triangle, set on heavy spars, which supported a platform high above the ledge, on which the drilling machinery was installed.