In knitting across, the meshes will accumulate on the fid; shove them off to the left, a few at a time, to make space for others. When the desired number of meshes are finished to form the first row, shove them all off the fid, as shown in Fig. 24. Begin the next row by again placing the fid under the cord (Fig. 24). Take up the first mesh, drawing it close to the mesh-stick, hold it in place with the thumb while throwing the cord over your hand, pass the needle on the left-hand side of the mesh from under through the loop (Fig. 25); pull this tight, and you will have tied the common knitting-knot. Repeat this with all the loops until the row is finished. When it becomes necessary to thread or fill the needle, tie the ends of the cord with the knot shown in Fig. 26, which, when properly tightened, cannot slip. Wrap each end of the cord from the knot securely to the main cord with strong thread, to give the net a neat appearance. Continue netting until the net is three feet wide. Then untie the rope, and spread the net by sliding the knots apart, and fasten the second rope to the bottom of the net by tying the rope securely to the first mesh with the cord on the needle; then carry the rope and cord to the next mesh, hold the rope, cord, and mesh firmly in place, and throw the cord over your hand, passing the needle down through the mesh under the rope and cord out through the loop (Fig. 27). Pull this tight, and continue in like manner, knitting each successive mesh to the rope until the net is all fastened on. Turn back the end of the rope and wrap it down neatly with strong string (Fig. 28). In the same way secure the other end, and also the ends of the first or top rope. [Illustration: Fig. 25.] [Illustration: Fig. 26.] This completes the lawn-tennis net proper. The bright tassels can now be tied at intervals along the top of the net, and four pieces of twine fastened on each end of the net at equal distances apart. These are for tying the net to the poles (Fig. 29). [Illustration: Fig. 17] [Illustration: Fig. 18] To erect the lawn-tennis net, plant the two poles firmly in the ground a little over thirty-three feet apart, tie the net to the poles, then drive in the pegs, two to each pole, about five feet from the pole (Fig. 30); slide a runner on each end of the two guy-ropes by first threading the rope through one of the holes in the runner, then pass the rope over the side down through the other hole and fasten it with a knot (Fig. 15). Next tie around the notch in the top of the poles the guy-ropes, with runners attached, and slip each loop made by the runner over each peg (Fig. 31), allowing the rope to fall in the groove A near the top of the peg; tighten the rope by pushing up the runners. The stakes are thus held in position by ropes running out to the pegs in the ground (Fig. 30). [Illustration: Fig 27] [Illustration: Fig. 30.—The Home-Made Net.]