Produced by Colin Bell, Joseph Cooper, David Wilson and the Online Distributed Proofreading Team at https://www.pgdp.net INTRODUCTION OF THE LOCOMOTIVE SAFETY TRUCK _by John H. White_ Paper 24 pages 117-131, from CONTRIBUTIONS FROM THE MUSEUM OF HISTORY AND TECHNOLOGY UNITED STATES NATIONAL MUSEUM Bulletin 228 Smithsonian Institution Washington, D.C., 1961 Contributions from The Museum of History and Technology: Paper 24 Introduction of The Locomotive Safety Truck _John H. White_ INTRODUCTION OF THE LOCOMOTIVE SAFETY TRUCK _John H. White_ _Pioneer railroading was dangerous. With increased speed and density of traffic came an increase in catastrophic wrecks that forced operators to take heed for the safety of their passengers and freight. This safety was painfully achieved through the slow process of improving equipment part by part._ _Antedating such spectacular post-Civil War advances as the steel rail, automatic coupler, and airbrake, was the invention of the safety truck for locomotives. Intended to lead the bobbing, weaving locomotive around curves on the rough track of the early roads, it did much to reduce the all too numerous derailments that were a major cause of accidents._ The Author: _John H. White, is associate curator, in charge of land transportation, in the Smithsonian Institution's Museum of History and Technology, United States National Museum._ American railroads of the early 19th century were cheaply and hastily built. They were characterized by inferior roadbeds, steep grades, sharp curves, and rough track. In spring, poor drainage and lack of ballast might cause the track to sink into the soggy roadbed and produced an unstable path. In winter this same roadbed could freeze into a hard and unyielding pavement on which the rolling stock was pounded to pieces. In those pioneering times the demand for new roads left little capital to improve or expand existing lines; therefore equipment was needed that could accommodate itself to the existing operating conditions. The first locomotives used in this country had been imported from England. Designed for well-ballasted track with large-radius curves and gentle gradients, they all too frequently left the rails, and the unsuitability of the essentially rigid British design soon became apparent. The challenge posed by the American roadbed was met by American mechanics. By the mid-1830's a distinctive American locomotive had evolved that might best be described by the word "flexible." The basic features of its running gear were a bar frame and equalizing levers to provide vertical relief and a leading truck to provide lateral relief. Of these devices the truck was probably the most important, and more readily than any one component distinguished the American running gear from that used by the British before 1860.