How was the landside handle attached? W. E. Bridges of the National Museum suggests that it might have been attached to the lower side of the standard and the rear end of the plow beam. This seems, beyond doubt, to be correct. The wood has deteriorated considerably over the years and the joints are loose, but, within the limits of the existing structure, the plow beam can easily be set in such a position that its sloping rear end lines up with the slope of the underside of the standard. Furthermore, a long bolt runs from the upper part of the moldboard through the standard and projects quite far beyond its lower surface, as can be seen in figure 7. The end of the bolt is threaded only part way and it has been necessary to put a cylindrical metal spacer on it in order to draw up the nut snugly. This long bolt must originally have passed through the lower end of the handle, which, in turn, was fastened to the end of the plow beam by a tenon on the end of the beam, now broken off, passing through a mortise in the handle. This was the common method of fastening the handle to the beam. The square hole in the plow's iron landside (fig. 7), which at first might seem meant for another bolt passing through the lower end of the handle at right angles to the long bolt, seems too close to the other bolt and to the edges of the handle. It may simply be a first try for the bolt through the bottom of the standard. In this manner the handle would have been strongly attached to the plow frame and, at the same time, would have materially helped to make it rigid by forming one side of a triangular structure. Figures 8 and 10 show what I believe to be the correct reconstruction of the 1838 Deere plow along the lines just described and, therefore, the probable appearance of the 1837 plow. [Illustration: Figure 10.--RECONSTRUCTION OF DEERE'S 1838 PLOW, left side, showing how left handle is believed to have been attached. (_Smithsonian photo 42637_.)] It should also be noted that it was general practice in making fixed moldboard plows to have the plow beam, standard, handle, and landside (or sharebeam, on the old plows) in the same plane. Symmetrical handles branching from both sides of the beam are found on cultivators, shovel plows, middle busters, and sidehill plows where the moldboard is turned alternately to each side. IN SUMMARY-- The existing evidence, I believe, indicates that: 1. The successful prairie plow with a smooth one-piece moldboard and steel share was basically Deere's idea. 2. The moldboards of practically all of his plows, from 1837 and for about 15 years, were made of wrought iron rather than steel. 3. The success of his plows in the prairie soils depended on a steel share which held a sharp edge and a highly polished moldboard to which the sticky soils could not cling. 4. The importance attached to the steel share led to the plows being identified as steel plows.