Bleeding Bleeding should be done as quickly as possible after the animal is down, using a straight boning knife and holding the animal in position with the knee on or behind the shoulder. Grasp the lower jaw with the left hand, pull the head back and insert the knife just back of the jaw where the angle is made (fig. 3). With the cutting edge to the outside, insert the knife as close to the neck bone as possible. Cut clear through and then outward, severing the windpipe, gullet and blood vessels (fig. 4). [Illustration: Man inserting knife near the jaw of the sheep] Figure 3.—Bleeding. [Illustration: Man finishing the cut of the sheep’s neck] Figure 4.—Bleeding. Pelt Removal Hands and equipment must be kept clean in order to produce a clean carcass. Dirt and wool on the carcass are very difficult to remove and usually have to be trimmed. Make certain there is a good supply of clean water available at all times. Also, pelting (fisting) is much easier if the hands are kept slightly wet. _Legs, Breast and Midline_.—The pelt can be opened around the legs and along the midline and breast from the horizontal or suspended position. The procedure selected depends on personal preference and the equipment available. _Horizontal method_.—Place the animal on its back on a clean floor (concrete, slate, or piece of plywood) (fig. 5). Standing to one side of the lamb, hold one front leg between your knees and allow the lamb to lean away. Remove a narrow strip of skin down the front of the foreleg, being sure to remove the skin over the knee (fig. 6). Turn the knife (with the cutting edge toward the skin) and make an opening to the neck in front of the breast (fig. 7). Make certain to cut toward the skin to avoid cutting through the thin membrane (fell) covering the outside of the carcass. If this membrane is broken, the lean muscles will bulge through and give the carcass an unattractive appearance. [Illustration: Sheep lying supine on a plywood sheet] Figure 5.—Horizontal position. [Illustration: Man cutting pelt off front leg using a knife] Figure 6.—Skinning foreleg. [Illustration: Man cutting pelt up leg to breast using a knife] Figure 7.—Skinning neck. Skin the opposite leg the same way, meeting the cut made in front of the breast. Open the pelt down the neck to the opening made by sticking (fig. 8). This will form a V-shaped strip of pelt over the breast. Remove the pelt over the breast by pulling the pelt up and back. Once started, it is best to complete by fisting. Push the fist under the pelt with the knuckles next to the carcass and the thumb over the first finger (fig. 9). Press the fist up against the skin working it away from the carcass. Work slowly and avoid tearing through the fell and muscles. After the pelt is loosened over the brisket (fig. 10), stop and skin out the rear legs.