[Illustration: Fig. 8. Sand allows air to pass through it, and so water runs out of the bottle. Clay does not let air pass, and the water is therefore kept in, even though the tube is open.] This also explains something else that you may have noticed. If you tried baking one of your model bricks in the fire you probably found that the brick exploded and shattered to pieces: the water still left in the brick changed to steam when it was heated, but the steam could not escape through the clay, and so it burst the clay. In a brick works the heat is very gradually applied and the steam only slowly forms, so that it has time to leak away, then when it has all gone the brick can be heated strongly. You should try this with one of your model bricks; leave it in a hot place near the stove or on the radiator for a week or more and then see if you can bake it without mishap. Let us now compare a piece of clay with a brick. The differences are so great that you would hardly think the brick could have been made from clay. The brick is neither soft nor sticky, and it has not the smooth surface of a piece of clay, but is full of little holes or pores, which look as if they were formed in letting the steam out. A brick lets air through; some air gets into our houses through the bricks even when the windows are shut. Water will get through bricks more easily than it does through clay. After heavy rain you {17} can often find that water has soaked through a brick wall and made the wall paper quite damp. A pretty experiment can be made with the piece of apparatus shown in Fig. 9: bore in a brick a hole about an inch deep and a quarter of an inch wide, put into the hole the piece of bent glass tubing, and fix it in with some clay or putty, then pour some water blackened with ink into the tube, marking its position with a label. Stand the brick in a vessel so full of water that the brick is entirely covered. Water soaks into the brick and presses the air out: the air tries to escape through the tube and forces up the black liquid. [Illustration: Fig. 9. A brick standing in water. The air in the brick is driven inwards by the water and forces the liquid up the tube in order to escape]