"Mr. Homfray's, of the 10th September.--'Our great engine goes on extremely well here, nothing can go better; the piston gives no trouble; it goes about three weeks, and we work it with blacklead and water; the cylinder is as bright as a looking-glass; it uses about 2 lbs. of blacklead in a week; about once in twelve or fifteen hours we put a small quantity of blacklead, mixed with a little water, through the hole in the cylinder screw, and we never use any grease. We rolled last week 140 tons of iron with it, and it will roll as fast with the both pair of rolls, as they can bring to it.' "Mr. Wood's letter, September 12th.--'We are going on, as it is likely we always shall, in the old dog-trot way, puddling and rolling from the beginning of the week till the end of it. Your engine is the favourite engine with every man about the place, and Mr. Homfray says it is the best in the kingdom.' "I have not the smallest doubt but that I can make a piston without any friction or any packing whatever, that needs not to have the cylinder screw taken up once in seven years. It is a very simple plan, and will be perfectly tight; it is by restoring an equilibrium on both sides of the piston. I expect to see you in London soon, and then will give you the plan for inspection before I put it in practice. "I am very much obliged to you for recommending these engines in Cornwall, but you have not stated in what manner they are to be applied; whether to work pumps, or barrels, or both. They may be made both winding and pumping engines at the same time, if so required. "A rotative engine will cost more than an up-and-down-stroke, on account of the expense of the fly-wheel and axle. An engine capable of lifting 180 gallons of water per minute 20 fathoms would cost, when complete and at work, patent right included, about 220_l._ If it is a rotative engine, with a winding barrel, it will cost 270_l._ I expect that a 7-inch cylinder would be sufficient for winding at Penberthy Crofts, which might have a Crank on the fly for lifting water in pumps, and a winding barrel on its back. This would cost about 170_l._; the erection of them, when on the spot, will cost nothing. You do not say when you intend to be in town. I hope you will be present when the dock-engine is set to work. "The engines first sent to Cornwall, must be from Coalbrookdale; then they will be well executed, but from Wales it would not be so. "You may depend on having a real good engine sent down, with sufficient openings given to the passages.