=Conditions of a Lightning Conductor.=--From the consideration of the functions which it has to fulfill, we may now infer what are the conditions necessary for an efficient lightning conductor. The first condition is that the end of the conductor, projecting into the air, should have, at least, one sharp point. Our experiments have shown us that a pointed conductor tends, in a manner, to suppress the flash of lightning altogether; whereas a blunt conductor, or one ending in a ball, tends only to make it harmless when it comes. It is evident, therefore, that the pointed conductor offers the greater security. But a fine point is very liable to be melted when the lightning falls upon it, and thus to be rendered less efficient for future service. To meet this danger, it has recently been suggested, by the Lightning Rod Conference, that the extreme end of the conductor should be a blunt point, destined to receive the full force of the lightning flash, when it comes; and that, a little lower down, a number of very fine points should be provided, with a view to favor the silent discharge. This suggestion, which appears admirably fitted to provide for the twofold function of a lightning conductor, deserves to be recorded in the exact terms of the official report. “It seems best to separate the double functions of the point, prolonging the upper terminal to the very summit, and merely beveling it off, so that, if a disruptive discharge does take place, the full conducting power of the rod may be ready to receive it. At the same time, having regard to the importance of silent discharge from sharp points, we suggest that, at one foot below the extreme top of the upper terminal, there be firmly attached, by screws and solder, a copper ring bearing three or four copper needles, each six inches long, and tapering from a quarter of an inch diameter to as fine a point as can be made; and with the object of rendering the sharpness as permanent as possible, we advise that they be platinized, gilded, or nickel plated.”[29]