4. The leads PX and BY (fig. 16) should be of loading or other heavily insulated wire. They must be carefully insulated from each other, from the ground, and from the walls or other parts of buildings. This is especially true of the cable lead PX. In damp weather porcelain-knob insulators and porcelain tubes (the latter for use in passing through walls or partitions) may not be sufficient to afford proper insulation for the cable lead. In such case the latter should be suspended _in the air_ from the testing switch to the cable tank by means of several chains of paraffined porcelain insulators suspended by marline or protective tape which has been boiled in paraffin. These suspensions should be in each case under cover and should be kept as dry as possible. The length of the leads is immaterial. If loading wire is used, the distance between supports should be short (not over 50 feet), as this wire stretches considerably from its own weight, pulling out the insulation and giving a very thin wall, particularly at points of support. Extreme care should be taken to tighten up on the knob insulators, in case they are used, just enough to hold the wire without pinching the insulation. 5. Using a double connector, join the lead BY to the ground wire on the cable above the surface of the water. Put a connector on the end of the other lead so that it can be readily attached in turn to each conductor. 6. Any protective covering, such as armor, jute, etc., should be removed from the ends of the conductors for a distance of about 12 inches, thus laying the insulation coating bare. This latter should not be handled and must be kept scrupulously clean. With a _clean dry_ knife prepare each conductor of the cable to be tested by cutting off about 1 inch of the insulation from each end of the wire and then tapering the end of the insulation for about 1 inch, leaving a perfectly clean surface. In damp weather dip each end of each conductor into melted paraffin (not boiling, but heated above 212° F.). Secure one end of the cable so that it is well separated from the surrounding objects and separate the conductors so that no ends are touching. 7. Take one strand of a loading wire about 4 feet long and wrap it two or three times around the projecting copper end of each conductor at the other end of the cable, then connect it to earth. See that the conductors at this end are dry. Leave the lead PX disconnected and suspended in the air. =II. Setting up the testing apparatus.=—1. Select a light, dry room as near the cable tank as practicable. 2. Use dry cells for the battery. The voltage of the battery should be such as to give a full scale deflection of the galvanometer through the resistance employed for taking the constant (with shunt at ¹/₁₀₀₀). Large galvanometer throws are essential for reliable results.