Meta toluene sulphonic acid and related compoundsAllen, C. F. H. (Charles Francis Hitchcock)
Science
Meta toluene sulphonic acid and related compounds
Allen, C. F. H. (Charles Francis Hitchcock)
Organic compounds -- Synthesis; Sulfonic acids
In this case an excess of ortho toluidine was used. The red dyestuff
was formed in great amount and very easily. The temperature was kept
below 195 to lose none of the toluidine which boiled at 199.
Experiment 4.
This method gave the best results and is the one employed in the
preparation of all the material used in the thesis. Equal weights of
ortho toluidine and sulphuric acid (100gms. of each were used; 100gms.
of ortho toluidine is 108cc., and 100gms. of sulphuric acid (s. g.
1.84) are 56cc.), were mixed and baked at 190-195 until a sample would
dissolve in ten per cent sodium hydroxide solution to give a clear
solution; this took one and a half hours. The mixture at first melts
in the solution of the sulphate and sulphuric acid formed by the heat
of combination; as heating is continued it gradually becomes solid and
finally very hard; it has become gray in color. When it is perfectly
dry a test is made to see if it dissolves in sodium hydroxide giving a
clear solution. If so, sulphonation is complete. By using an oven with
a glass door the reaction mixture can be watched and the completion of
the baking observed. However the test for complete solubility should
always be made. The addition of powdered oxalic acid to the reaction
mixture did not seem to be of advantage, because no visible reaction
commenced until this had been driven off or decomposed. It is usually
added in producing sulphonic acids by baking the sulphates of the
amines to increase the porosity of the mass and thus facilitate removal
of the product. However here the only effect seemed to be to retard
the reaction, as the product was the sane hard grayish mass as without
the acid, and it was just as difficult to dig it out. It took an hour
longer to complete the reaction with the addition of the oxalic acid.
The best results were obtained when the temperature of the oven was
kept at 193, although five degrees variation did not appreciably affect
the product. A lower temperature gives little or no action, while a
higher one drives off the ortho toluidine and also seems to favor the
formation of the red dyestuff.
As stated above, complete sulphonation is shown by the solubility of
the acid in ten per cent sodium hydroxide solution. If any unchanged
amine is present as sulphate the solution will become milky due to
liberation of the insoluble amine. On boiling a solution of the acid a
slight hydrolysis takes place so that the smell of ortho toluidine is
present, yet the solution is always perfectly clear.
Public-domain text, read in full here on John Shaqi.
Reviews
Reviews
No reviews yet
Be the first to share your thoughts on this work.
Join the Discussion
Join the discussion
Sign in to leave a comment or review.
Sign InorCreate an account