TO MAKE THE PACK (Fig. 8).--Spread the shelter half on the ground and fold in the triangular ends, forming an approximate square from the half, the guy on the inside; fold the poncho once across its shortest dimension, then twice across its longest dimension, and lay it in the center of the shelter half; fold the blanket as described for the poncho and place it on the latter; place the shelter tent pins in the folds of the blanket, in the center and across the shortest dimension; fold the edges of the shelter half snugly over the blanket and poncho and, beginning on either of the short sides, roll tightly and compactly. This forms the pack. TO ASSEMBLE THE PACK (Fig. 9).--Place the pack in the pack carrier and grasp the lower suspension rings, one in each hand; place the right knee against the bottom of the roll; pull the carrier down and force the pack up close against the bottom of the packed haversack; without removing the knee, pass the lower carrier binding strap over the pack and secure it by means of the opposite buckle; in a similar manner secure the lower haversack binding strap and then the upper carrier binding strap. Engage the snap hook on the pack suspenders in the lower suspension rings. The equipment is now assembled and packed as prescribed for the full equipment. TO ASSEMBLE THE FULL EQUIPMENT. (_Without Rations._) Place the assembled equipment on the ground as heretofore described; fold up the inside flap of the haversack so that its end will be on a line with the top of the haversack body; fold up the lower haversack strap in the same manner. TO MAKE UP THE PACK.--Fold the poncho, blanket and shelter half, and make up the pack as heretofore prescribed, except that the condiment and bacon can (the former inside the latter) and the toilet articles and socks are rolled in the pack. In this case the pack is rolled, beginning on either of the long sides instead of the short sides, as heretofore described. TO ASSEMBLE THE PACK.--Place the pack on the haversack and pack carrier, its upper end on a line with the upper edge of the haversack body; bind it to the haversack and carrier by means of the haversack and pack binding straps; fold down the outer flap on the haversack and secure it by means of the free end of the middle haversack banding strap and the buckle provided on the underside of the flap; engage the snap hooks of the pack suspenders in the lower suspension rings. The equipment is now packed and assembled (Fig. 10).