In general two plans are followed in building a motor truck. The first is to build a rigid truck so that it will resist all shocks and distortions that come from rough and uneven roads. The second plan is to build a flexible body so that the chassis will "give" rather than resist when subjected to hard strains. Although the rigidly-built truck may be entirely satisfactory for most forms of trucking, it is practically impossible to build one on the rigid principle that will stand up under the heavy strains to which a logging truck is subjected unless it is to be operated over good paved roads. When only ordinary unpaved public roads are available, flexibility is one of the most important characteristics to look for when selecting a truck. Where the operator is hauling over his own pole or plank road this consideration does not play so important a part, as the road bed then is more likely to be free from holes and irregularities. All makes of trucks are more or less alike in general construction, differing only in minor details, so that the personal whims of the buyer will largely determine the kind he will select. It is advantageous to have as long a distance as possible between the driver's seat and the bunk over the rear axle, in order to allow more of the load to be carried by the truck, and less by the trailer, giving better traction to the drive wheels, but necessitating extra strong rear springs and axles. The type of power transmission best suited to the use of the logging truck is a question that has received a great deal of attention. There are three general methods of transmitting the power: (1) by chain; (2) by worm drive, and (3) by internal gear drive. Each has its advantages. It is claimed by many that the chain drive saves many hours of "shut-down time" due to the fact that if anything breaks in the transmission, it will be a link in the chain as this is the weakest point. It is then only a matter of a few minutes to insert another link. With the worm driven vehicle, a break in the transmission requires an expensive shut-down before the matter can be repaired. The worm drive, on the other hand, very seldom breaks if proper care is used. The chain drive also allows the replacement of the sprocket with one of a larger or smaller diameter thereby giving a higher or lower gear ratio, which cannot be done with the worm gear. This seems to be of some advantage to an operator when changing his setting from one with a short haul and steep grades where a low gear ratio is required, to one where the haul is long and fairly level, and where speed in transit is an advantage.