DEPARTMENT OF ELECTRICAL ENGINEERING Professor J. C. Peet Professor A. A. Nims Asst. Prof. S. Fishman Asst. Prof. F. E. McKone Asst. Prof. P. C. Shedd Mr. J. H. Johnston Mr. W. Jordan, 3rd Mr. F. A. Russell Mr. C. H. Stephans The problems and techniques associated with the production, delivery, utilization and control of energy in the electrical form are given the inclusive title of Electrical Engineering. Any general preparation for the recognition and analysis of these problems and the mastery of these techniques, in their infinite variety, must, of necessity, emphasize the basic conceptions and principles which are of widest application. Specific applications, sufficient in number and variety to maintain the student’s interest and broaden his point of view are, however, useful supplements. The work of the freshman and sophomore years consists, primarily, of the foundation mathematics, physics, English and mechanical drafting usually given to all engineering students. In addition, a course in the fundamental electrical units and their application to the magnetic, electro-static and electric circuits, is given. This is followed by a general engineering course in d-c and a-c circuits. The classroom work is paralleled by a laboratory course in electrical measurements. During the upper class years the principles of electrical engineering are applied to many problems; characteristics and operation of direct-current, synchronous, and induction machinery, rectification, wave form analysis, transient phenomena, power plant equipment, transmission and distribution and electro-physical measurements in magnetism, in induction and capacitance by balance methods and in multi-electrode vacuum tube characteristics. A student branch of The American Institute of Electrical Engineers holds about eight or ten meetings each year. All upper classmen become members and are expected to attend its meetings. The second year men are invited to join the local society. Since electrical engineering is closely related to mechanical and chemical engineering much material from these branches is included in the course. The Electrical Laboratories The electrical laboratories are located on the first floor of the Laboratory Building. A centrally located stock room houses much of the equipment used for test and measurement. Electric power for the laboratories is obtained from the Public Service Electric & Gas Company through a 240-volt, 3-phase, 60-cycle alternating current line. By means of transformers, motor-generator sets, synchronous converters, oscillators, rectifiers, and storage batteries, direct or alternating current power of wide range of voltage and frequency is available. This power can be distributed to any part of the laboratories on either two or three wire lines, through a carefully planned distribution system.