In a 2-l. beaker, 180 g. of technical dimethylaniline, 125 cc. of formaldehyde (technical 40 per cent), and 300 cc. of concentrated hydrochloric acid are mixed and heated for ten minutes on a steam bath. The mixture is now placed in a hood and the nitroso dimethylaniline added all at once, or as rapidly as possible. The beaker is then covered with a watch glass. A vigorous reaction soon occurs and is complete in about five minutes. The resulting solution is transferred to a 5-l. flask and diluted to 4 l.; stirring is started, and a 25 per cent solution of sodium hydroxide is added until the red color disappears (about 650 cc. are required). The yellow benzylidene compound separates, is filtered with suction and washed with water. The moist precipitate is transferred to a 4-l. glass jar, covered with 1000 cc. of 50 per cent acetic acid and 250 cc. of formaldehyde, and stirred until twenty minutes after the benzylidene compound has gone into solution. While the mixture is being stirred vigorously to prevent lumping of the precipitate, 400 cc. of water and 200 g. of cracked ice are added during the course of five minutes. The dimethylaminobenzaldehyde generally separates gradually in fifteen to twenty minutes, but in some cases does not. If the precipitate does not form, the solution is placed in a refrigerator for a few hours or overnight. The mixture is filtered with suction and washed at least ten times with 300 cc. of water. The precipitate is sucked as dry as possible for fifteen to thirty minutes. The slightly moist aldehyde is distilled under diminished pressure from an oil bath, by means of a 1-l. Claisen flask. A small amount of water comes over first, then the thermometer rises rapidly to the boiling point of the aldehyde (180'0/22 mm.). In changing receivers between the water fraction and the aldehyde, care should be taken to keep the side-arm of the distilling flask warm; otherwise, on starting the distillation again, the aldehyde will solidify in the side-arm and cause trouble. It is advisable not to collect the very last portion of the distillate with the main portion, as the former is frequently quite red. This is best added to crude material from another run. The main distillate is dissolved in 100 cc. of alcohol in a 2-l. beaker, then 1000 cc. of water are gradually added with vigorous mechanical stirring to prevent lumping. The aldehyde separates, and is filtered with suction. The product, when dry, weighs 125-130 g. (56-59 per cent of the theoretical amount), and melts at 73'0.