As the excavation becomes larger and deeper, more overburden is removed, and the upper portions of the launder are taken away, until at last the stopes reach the level, when the launder is, of course, no longer required. At first, the sand is thrown out by one or two “throws,” but very soon it becomes necessary to put in an inclined road, for pulling up the sand in waggons; these are worked by a horse-whim, or by winding gear attached to the engine or water-wheel. As there are from three to eight tons of sand to each ton of clay, its removal in the cheapest possible manner is a matter of great importance. Any veins or lodes of stone, or discoloured portions of clay, are raised from the “bottoms” in the same way as the sand. The stream of water, holding in suspension clay, fine sand, and mica, is, in well-arranged works, lifted at once high enough to allow of all subsequent operations being carried out by the aid of gravity. The stream is first led into one or two long channels, the sides of which are built of rough stone. In these channels, called “drags,” the current suffers a partial check, and the fine sand and rougher particles of mica are deposited. From these drags, the stream passes on into other channels, much resembling them, but of greater number, so as to divide the stream still further. This second series of channels, known as “micas,” are often built of wood, but sometimes of stone. They differ in no essential respect from the drags, but are more carefully constructed and better looked after, and, as the stream is greatly divided and very gentle, the fine mica is deposited in them. The micas are often about 11 inches wide, ten or a dozen in number, and 100 feet or more long. Provision is made, by underground channels and plug holes, for the periodical cleansing of the drags and micas. This may have to be done twice a day, but generally only once. The deposit in the drags is worthless at present, and is always thrown away; but that from the micas is often saved, and sold as inferior or “mica” clay. The refined stream of clay then passes on to the “pits,” which are circular, 30 to 40 feet diameter and 7 to 10 feet deep. These pits are built of rough masonry, and have an outlet at the bottom, opposite the point at which the stream of clay-water is admitted. This outlet is stopped by a gate or “hatch,” or by a plug, and is kept closed until the pit is full of clay. In each outlet, however, is fixed an upright launder some 4 inches square, provided with “pin-holes” and wooden pins set close together. As the stream of clay enters on one side, it is constantly depositing its burden, and the water is as constantly drawn off nearly or quite clear from the pin holes, the pins being put higher and higher as the clay rises in the pit. The effluent water is conducted directly to small storage reservoirs, and thence over the clay stopes, whence it does its work over again.