Pigments, Paint and Painting: A practical book for practical menTerry, George
Science
Pigments, Paint and Painting: A practical book for practical men
Terry, George
Paint; Painting, Industrial; Pigments
Two modes of building with rough stone are adopted; they are known as
“lime building,” and “dry stone walling.” The first needs no special
remark, but the second is very ingenious and very effectual. The wall
is built up double, with a batter of about ¾ inch or 1 inch to the
foot. Moss is placed between the joints of the wall, and the space
between is filled in with sharp sand, the refuse of that or some other
clay works. A small stream of water is then made to flow over the sand,
which is well beaten in with rammers, or by treading with the feet.
This process is continued, a foot at a time, till the wall reaches the
required height, when it is either paved with rough stones set on edge,
or turfed. A wall properly built, in the manner just described, is
quite impervious to moisture, and will stand for fifty years or more.
It is, where the proper kind of sand is abundant, much cheaper than
lime walling, and is always preferred for the walls of pits and tanks.
Where the bed of clay is situated on a hill-side, with plenty of space
below, a tunnel is driven in from the hill-side or from the valley to
the required depth, and a rise is put up as before. This rise is then
divided off into two parts. In the smaller, a button-hole launder is
placed as before, and packed around with clay; but the larger is left
open. A stream of water, obtained by pumping or otherwise, is made to
run over the stope, and down the button-hole launder. It then flows
along a launder placed in the bottom of the level, until it makes its
exit in the valley. It may then be purified, settled, and dried exactly
as already described--the works being laid out at a lower level than
the adit; or, if the clear water is wanted to flow over the stope,
or it is, for any reason, necessary to place the pits and tanks at a
higher level than the stopes, the water is pumped up after partial or
complete purification.
The main difference in this mode of working is that instead of pulling
the sand and rubbish up over an incline, it may be tipped down the
pass into waggons, run out through the level, and tipped over the
hill-sides. In cases where waste water is abundant, it may even be
washed out at night, thus saving the expense of tramming. Of course,
when the workings have reached their full depth, the rise and the
launder are dispensed with, and the adit level communicates directly
with the “bottoms.” By this mode of working a considerable economy may
be effected, especially when it is not necessary to pump the clay water
for settling or repeating.
Public-domain text, read in full here on John Shaqi.
Reviews
Reviews
No reviews yet
Be the first to share your thoughts on this work.
Elsewhere in the archive
Join the Discussion
Join the discussion
Sign in to leave a comment or review.
Sign InorCreate an account