secured at its centre to the tube. Round the periphery of this plate is a vertical rim of tin plate, at the top of which is a pipe through which the cooling water runs into a gutter round the top of the cylindrical casing, the water being carried off from this gutter by a pipe. The vertical tube is carried near its upper end in a bearing, and at that part is attached a worm-wheel geared into it by a worm driven by any suitable power. At the underside of the circular plate is fixed a scraper, the edge of which is formed with a strip of leather in contact with the lower surface of the plate. Opposite the scraper, at the bottom of the casing, is a burning lamp, which sucks up the oil for its consumption by a flat wide wick. The operation is as follows:--The vertical tube is caused to revolve by the action of the worm-wheel, the circular plate thereby receiving a slow rotary movement; and a small stream of water being poured into the funnel at the top of the tube, this water passes down the latter and through the openings on to the circular plate, which is thus kept cool. The burning lamp filled with paraffin or other oil is brought as near to the circular plate as is necessary for the cooling of the flame and the most perfect extraction of the carbon, which, in the form of soot, attaches itself readily to the plate, owing to its coldness and to the condensation of the steam produced. The revolving plate presents continually to the flames a new and clean surface, in consequence of the lamp-black being scraped away by the scraper as soon as deposited, and brought away through a pipe or shoot into a collecting barrel. The apparatus as shown in Figs. 7 and 8 consists of a round metal plate A, provided with a flange _a_, and fixed on a vertical shaft _b_ supported by the bearing B, and carrying at its upper end a worm wheel _d_ set in motion by a worm. The plate A is cooled by water admitted through a pipe _g_, and the flange _a_ is provided with a discharge pipe _h_, through which the cooling water runs into the groove D, surrounding the whole apparatus. Underneath the plate A a number of lamps J are applied, which are fed with oil by a common pipe _l_. H is an oblique scratcher or blade, the working edge of which is formed by a strip of leather, and touches the lower surface of the plate A.